Vaxcel T0451 Instruction manual

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
181029
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0451 / T0455
Lock Nut (E)
Mounting Screw (B) Wire Connector (F) Ball Nut (G) Rubber Pad (H)
Cross Bar (A) Green Grounding
Screw (C)
Headless Screw (D)
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
Turn off the power at fuse or circuit box
Installation Steps
1. Thread two headless screws (D) through the cross bar (A), and then secure
them with four lock nuts (E). Adjust the length of the headless screws (D)
if necessary.
Note: Make sure that the headless screws are lined up horizontally to
make the fixture level.
2. Attach the cross bar (A) to the outlet box by using two mounting screws (B).
3. Pull out the source wires from the outlet box. Make wire connections using
wire connectors (F) as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black
wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the
white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to
the cross bar with the green grounding screw (C), and then connect it to
the house grounding wire with the wire connector (F).
Carefully put the wires back into the outlet box.
Ball Nut (G)
Replacement Ball Nut
Bulb Type A
Max. 60W
(not included)
Glass
Rubber Pad (H)
Wire Connector (F)
Outlet Box
Lock Nut (E)
Mounting Screw (B)
Fixture Wire
Green Grounding Screw (C)
Cross Bar (A)
Fixture Grounding Wire
Fixture
Headless Screw (D)
Back Plate

181029
Assembly Kit
6001MM (1SET)
Glass
T0451 10036CS
T0455 10037CS
The following parts are available for re-order if damaged or missing.
Spare Parts List:
T0451
A: 8”
B: 14-1/2”
C: 10”
T0455
A: 9-3/4”
B: 16-1/2”
C: 12”
Turn on the power at fuse or circuit box
Lock Nut (E)
Mounting Screw (B)
Wire Connector (F) Ball Nut (G) Rubber Pad (H)
Cross Bar (A) Green Grounding Screw (C) Headless Screw (D)
4. Attach the fixture to the cross bar by inserting headless screws into holes on back plate, and then secure it with two
rubber pads (H) and two ball nuts (G).
NOTE:With silicone caulking compound, caulk completely around where the back plate meets with the
wall surface to prevent water from seeping into the outlet box.
5. Install a bulb (not included). Check relamping label at socket area or packaging for maximum allowed wattage.
6. Attach the glass onto the fixture, secure it with four replacement ball nuts.
B
C
A