Viavi Seeker X with MCA III User manual

Seeker X with MCA III Installation Guide
1
2
3
4
Wire the DC power cable to the vehicle power source and then connect it to the back of the Seeker
X Mobile Mount.
Install the Seeker X Mobile Mount & Seeker MCA Ill in your vehicle*.
Connect the serial data cable between the Seeker X Mobile Mount and the Seeker MCA Ill (optional).
Connect the Seeker X Mobile Mount antenna connection to the vehicle antennas.
*Before installation ,
configure the Seeker X &
Seeker MCA Ill as shown
in the Seeker Setup User’s
Guide.
Mobile Mount & MCA Ill
rear view
Serial data cable
©  VIAVI Solutions Inc.
Product specifications and descriptions in this
document are subject to change without notice.
22137809
Rev 001, Jan 2020
English
*Connect the right angle connector of the diplexer
cable to the back of the mobile mount.
AVM-3
low-band
antenna
Mobile Mount & MCA Ill
rear view
Antenna diplexer
cable
Antenna diplexer
WVM-2
high-band
antenna
White wire
positive (+)
Black wire
negative (-)
DC power cable
Green wire
vehicle ignition
*Use the provided in-line fuse holders to wire the white & black DC power cables to
the vehicle battery as shown. Wire the green DC power cable to the vehicle key switch
to allow the MCA Ill to determine when the vehicle is turned OFF.
Mobile Mount & MCA Ill
rear view
Mobile Mount & MCA Ill
rear view

VIAVI Solutions
North America 1.844.GO VIAVI / 1.844.468.4284
Latin America [phone]
EMEA [phone]
APAC [phone]
All Other Regions viavisolutions.com/contacts
email T[email protected]om
Technical assistance
If you require technical assistance, call 1-844-GO-VIAVI / 1.844.468.4284.
For the latest TAC information, visit
http://www.viavisolutions.com/en/services-and-support/support/technical-assistance
5
6
Connect the GPS receiver and Ethernet cable to the Seeker MCA Ill (optional).
Connect the Wi-Fi antenna to the Seeker MCA Ill.
GPS receiver
Serial RS-232
connection
Mobile Mount & MCA Ill
rear view
Ethernet
connection
(optional)
Mobile Mount & MCA Ill
rear view Wi-Fi antenna