Viega Prevista Pure 8566 User manual

for urinals with concealed flushing system, urinal flush plates for
Prevista (manual and touchless flush actuation)
Model Year built:
8566 from 06/2019
en_INT
Prevista Pure urinal water pipe section
Instructions for Use

Prevista Pure urinal water pipe section 2 from 13

Table of contents
1About these instructions for use 4
1.1 Target groups 4
1.2 Labelling of notes 4
1.3 About this translated version 5
2Product information 6
2.1 Standards and regulations 6
2.2 Intended use 6
2.2.1 Areas of use 6
2.3 Product description 7
2.3.1 Overview 7
2.3.2 Technical data 7
3Handling 8
3.1 Assembly information 8
3.1.1 Mounting conditions 8
3.1.2 Installation dimensions 9
3.2 Assembly 10
3.2.1 Assembly 10
3.3 Disposal 13
Table of contents
Prevista Pure urinal water pipe section 3 from 13

1 About these instructions for use
Trade mark rights exist for this document; for further information, go to
viega.com/legal.
1.1 Target groups
The information in this instruction manual is directed at the following
groups of people:
nHeating and sanitary professionals and trained personnel
Individuals without the abovementioned training or qualification are not
permitted to mount, install and, if required, maintain this product. This
restriction does not extend to possible operating instructions.
The installation of Viega products must take place in accordance with
the general rules of engineering and the Viega instructions for use.
1.2 Labelling of notes
Warning and advisory texts are set aside from the remainder of the text
and are labelled with the relevant pictographs.
DANGER!
This symbol warns of possible life-threatening injury.
WARNING!
This symbol warns of possible serious injury.
CAUTION!
This symbol warns of possible injury.
NOTICE!
This symbol warns of possible damage to property.
This symbol gives additional information and hints.
About these instructions for use
Prevista Pure urinal water pipe section 4 from 13

1.3 About this translated version
This instruction for use contains important information about the choice
of product or system, assembly and commissioning as well as intended
use and, if required, maintenance measures. The information about the
products, their properties and application technology are based on the
current standards in Europe (e.g. EN) and/or in Germany
(e.g. DIN/DVGW).
Some passages in the text may refer to technical codes in Europe/
Germany. These should serve as recommendations in the absence of
corresponding national regulations. The relevant national laws, stand‐
ards, regulations, directives and other technical provisions take priority
over the German/European directives specified in this manual: The
information herein is not binding for other countries and regions; as said
above, they should be understood as a recommendation.
About these instructions for use
Prevista Pure urinal water pipe section 5 from 13

2 Product information
2.1 Standards and regulations
The following standards and regulations apply to Germany / Europe and
are provided as a support feature.
Regulations from section: Technical data
Scope / Notice Regulations applicable in Ger‐
many
Flush flow DIN 3265
Noise class DIN 4109
2.2 Intended use
2.2.1 Areas of use
The Prevista Pure urinal water pipe section is a universal compact-
design shell casing for urinals with concealed flushing systems and for
urinal flush plates for Prevista (manual and touchless flush actuation).
Product information
Prevista Pure urinal water pipe section 6 from 13

2.3 Product description
2.3.1 Overview

1 Plastic installation box
2 Flush-through plug
3 Cleaning cover
2.3.2 Technical data
Operating voltage 230 V / 50 Hz (infrared 230 V)
Magnetic coil 6 V
Flow pressure 0.05–0.5 MPa (0.5–5 bar)
Calculated flow 0.3 l/s
Flush flow, see Ä „Regulations
from section: Technical data“
on page 6
0.3–0.7 l/s
Noise class, see Ä „Regulations
from section: Technical data“
on page 6
2
Product information
Prevista Pure urinal water pipe section 7 from 13

3 Handling
3.1 Assembly information
3.1.1 Mounting conditions
9&"#%:$9
Fig. 1: Installation dimensions
A in accordance with manufacturer's documentation urinal ceramic
B in accordance with manufacturer's documentation urinal ceramic
C in accordance with manufacturer's documentation urinal ceramic
D in accordance with manufacturer's documentation urinal ceramic
E in accordance with manufacturer's documentation urinal ceramic
X upper edge of the finished floor
Y min. 40 mm
Installation dimensions
Handling
Prevista Pure urinal water pipe section 8 from 13

Location diagram for power pack, terminals, battery and control.
3.1.2 Installation dimensions



33.JO.BY
Fig. 2: Dimensional drawing
Handling
Prevista Pure urinal water pipe section 9 from 13

3.2 Assembly
3.2.1 Assembly
DANGER!
Danger due to electrical current
An electric shock can lead to burns and serious injury and
even death.
– Work on the electrics may only be carried out by trained
electricians.
– Switch off the mains voltage before carrying out work on
electrical parts.
INFO! The distance from the box to the sanitary object must be at
least 40 mm.
Determine and mark the fixing points.
Drill the holes and insert the dowels.
NJONN


Handling
Prevista Pure urinal water pipe section 10 from 13

Remove the site protection.
Fasten the urinal water pipe section to the wall.
Connect the water pipeline to the urinal water pipe section inlet.
Install the water pipeline from the urinal water pipe section up to the
sanitary object.
Handling
Prevista Pure urinal water pipe section 11 from 13

INFO! Connect a maximum of three elbows.
DANGER! Risk of electric shock. An electric shock can lead to
burns and serious injury and even death.
–Only allow electrical work to be carried out by qualified elec‐
tricians.
–Always de-energise the connection cable before work is com‐
menced.
–Once the product has been mounted and commissioned, hand
over this manual to the operator.
For infrared actuation, insert the cable laid by the customer into the
casing of the urinal water pipe section.
Insulate the pipe.
Replace the site protection.
Screw the seal plug in.
Handling
Prevista Pure urinal water pipe section 12 from 13

Wall in the urinal water pipe section.
INFO! Observe the maximum plaster thickness.
Plaster the urinal water pipe section and tile.
3.3 Disposal
Separate the product and packaging materials (e. g. paper, metal,
plastic or non-ferrous metals) and dispose of in accordance with valid
national legal requirements.
NN
Handling
Prevista Pure urinal water pipe section 13 from 13