Volt VSM-2407 User manual

VOLT®Low Voltage Landscape Lighting
VOLT® Path & Area Light Stem
VSM-2407 & VSM-1203
INSTALLATION INSTRUCTIONS
Specications and product details subject to change without notice.
© Copyright 2018, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3700
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)
- 1 -

VOLT®Path & Area Light Stem
VSM-2407 & VSM-1203
Important: Please Read Before Installation
Important Safety Instructions
INSTALLATION INSTRUCTIONS
This xture is intended for installation in accordance with local codes and
the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situations.
1. Make sure that the power is turned OFF before installing or servicing
this xture.
2. Warning: this xture is not intended to be installed within 10 feet [3
meters] of a pool, spa or fountain.
3. This xture is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Underground Low Energy Cable must not be buried over 6” (15.2 cm)
in order to connect to the main low voltage cable.
5. Wiring connections must be made with wire connectors that are
suitable for outdoor use.
6. Position the wire connector so that it is located within 6 inches (15.2
cm) from a building structure, a luminaire, or tting.
LIGHTED LAMP IS HOT!
WARNING – TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS.
1. Turn off/unplug and allow to cool before reducing lamp.
2. Lamp gets HOT quickly!
3. Do not touch the hot lens, guard or cowl.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time.
6. Use a soft cloth.
7. Oil from skin may damage lamp.
8. Do not operate the xture with a damaged or missing lens or shield.
!
!
www.voltlighting.com
- 2 -

Package Contents
Product Dimensions
A. (1) Stem
[email protected] • 813.978.3700
2.5”
9”
- 3 -
22.5”
Parts Required (sold separatly)
A. (1) Hat
B. (1) Bulb
C. Stake
Max Spread Hat Pictured Here

www.voltlighting.com
INSTALLATION INSTRUCTIONS
Remove Stem Top
1
Loosen the stem top and remove
it from the stem.
Stem Top
Stem
- 4 -
Install Bulb
2
Insert the bulb with correct wattage
and type marked on the xture label
and push rmly into place.
CAUTION: Do not exceed
maximum wattage marked on
luminaire label.
Socket
Bulb
Place the stem top over the
bulb and thread the stem top
onto the stem. Hand tighten
until snug.
Install Stem Top
3
Stem Top
Stem
VOLT®Path & Area Light Stem
VSM-2407 & VSM-1203

[email protected] • 813.978.3700
- 5 -
Install Stake
4
Determine the desired location for
mounting the xture. Hammer the
stake into the ground until the ange
of the stake is ush to grade. To avoid
damage to the stake, place a board
on top of the stake while hammering.
NOTE: If the ground is hard and the
stake is difcult to install, make a
crosscut in the ground using a at
shovel.
Board
Stake
Soil
Ground
Clear away an area in the ground
at the wireway slot on the top
of the stake. Lay the luminaire
pigtail into the wireway slot and
attach the stem onto the stake.
Tighten until snug.
Install Stem to Stake
5
Stem
Stake
Pigtail
Wireway Slot

INSTALLATION INSTRUCTIONS
www.voltlighting.com
- 6 -
Wire Connection
6
Strip both leads from the luminaire pigtail. Using two wire connectors
(sold separately), connect the leads from the luminaire to the main
supply cable leads.
Pigtail
Main Supply Cable
Wire Connectors
Install Hat
7
Place the hat of your choice onto
the stem top and secure it with
the nial. Hand tighten until snug.
Shield
Finial
Hat of your choice
Install/Replace Bulb
Remove the nial, hat and stem top to expose the bulb. Replace it
with the correct wattage and type marked on the xture label. Then,
reinstall the stem top and hat.
IMPORTANT: Bulbs must be protected from moisture and dust at all
times. Always reinstall the stem top and hat when removed.
VOLT®Path & Area Light Stem
VSM-2407 & VSM-1203

[email protected] • 813.978.3700
- 7 -

IS-VSM-2407/1203-ver1.pdf
Specications and product details subject to change without notice.
© Copyright 2018, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3700
www.voltlighting.com
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)
- 8 -