Watchguard WGSIR-500W User manual

Watchguard™ Wireless Siren & Strobe
Installation Manual
Model: WGSIR-500W
Product Features
• Easily connect the wireless transmitter at up to 100m range
• Loud siren sound with high-visibility strobe flashes
• Dual tamper switch protection for outer casing & wall mount removal
• Internal 7.2V rechargeable backup battery
This wireless outdoor siren is a cost-effective outdoor sounder. It features a waterproof, UV
resistant & anti-corrosive design with low battery consumption. With the NimH battery, it
can last up to 3 days with AC power cut off.

Specifications
Dimensions 300 x 220 x 65mm
Weight 1kg
Power Consumption 30mA @ 12VDC
Voltage Range 9~15VDC
Backup Battery 7.2V 500mA rechargeable
Siren Current 200mA @ 12VDC
Siren Volume 105±3dB at 1m
Flash Speed 60/min
Flash Current 120mA @ 12VDC
Wireless Signal 315MHz / 433MHz / 868MHz
Timers 5sec. (Test) / 3min. / 20min.
Lifetime Siren - 8hr usage / Flash: 24hr usage
Operating Environment -20° to 60°C
Material Polycarbonate
Case Protection UV, corrosion & water protection
Wireless Range
The transmitter has a wireless range of approximately 100m. This can vary depending on
walls or obstacles between the transmitter and the siren.
~100m

1. Connect the transmitter to the green port - RED wire to + (pos.) and WHITE wire to – (neg.)
2. Power the siren unit by connecting the battery. The LEDs will turn on if done correctly.
3. Press the anti-tamper switch. The LEDs will flash alternatively.
4. Press the “CODE LEARNING’ button on the siren 4 times. The LEDs will flash alternatively
faster, indicating the siren has entered code learning mode.
5. Power the transmitter with the 12VDC 500mA pack (included). The siren will learn the
transmitter, indicated by ‘LED2’turning ON and ‘LED1’turning OFF.
6. Remove the power pack - the siren will sound for few seconds, indicating the transmitter
has been coded to the siren unit.
7. Remove the transmitter and connect it to the siren port or pulse trigger output on the
Alarm Control Panel.
8. Make sure the 12V power pack and back-up battery are plugged in when the siren is
installed.
To reset the siren to factory default settings, press the‘CODE LEARNING’button 4 times.
Transmitter Code Learning
Factory Reset

Cut Off Siren Duration
The red 2-pin DIP switch on the siren adjust alarm time.
1. The top diagram (top circle) shows what to set the DIP switches to for the desired siren
duration. Refer to the table below for a more detailed description:
2. The 2-pin DIP switch (bottom circle) has two switches - 1 (A) and 2 (B).
ON = 1, OFF = 0
Siren Duration DIP Switch 1 (A) DIP Switch 2 (B)
15 Minutes 0 0
3 Minutes 0 1
1 Minute 1 0
Continuous 1 1