WB Manufacturing Rectangle CON6093 User manual

7
wibenchmfg.com 507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Step 1:
• Place top face down on a protected at surface.
Step 2:
• Locate one of the laminate legs. Align the pre-drilled pilot
holes on the leg with the pre-drilled holes on the top.
• Using a #2 square drive screw driver or a #2 square bit,
secure leg to top with angle brackets and #10 x ¾” square
pan screws.
• DO NOT FULLY TIGHTEN until Step 6.
Step 3:
• Align threaded inserts in the modesty panel with the pre-
drilled pilot holes in the leg.
• Using a 4mm Allen wrench or 4mm Hex bit and a screw
gun, secure modesty panel to leg with ¼-20x2.359” joint
connector bolts.
• Use 4 bolts total to connect panel to leg.
• DO NOT FULLY TIGHTEN until Step 6.
Step 4:
• With modesty panel in place, use a #2 square drive screw
driver or a #2 square bit and secure modesty panel to top
with angle brackets and #10 x ¾” square pan screws.
• DO NOT FULLY TIGHTEN until Step 6.
Step 5:
• Repeat Steps 2-4 with the second leg.
Step 6:
• Fully tighten legs and modesty panel fasteners.
Step 7:
• Place base leveler M10 into the hole on the bottom of one
of the legs. Rotate clockwise until fully inserted into the
leg. Repeat this for the remaining 3 levelers.
Step 8:
• With someone’s help, turn table upright.
Conference Tables
With Laminate Legs
Assembly Instructions
Before you begin, please make sure all parts and proper quantities are included. (See Part Identier Key) Any parts damaged during shipment must be reported
within 24 hours of receipt. To report information regarding damages or if you have any questions, please call 800.242.2303.
Tools Required
• #2 square drive screw driver OR
• #2 square bit
• Screw gun
• 4mm Allen wrench OR
• 4mm Hex bit
Boat Conference Table
Step 4
Step 3
Step 7
Step 2

8
wibenchmfg.com 507 E. Grant St. Thorp, WI 54771 • P - 800.242.2303
Part # Description Qty.
Hardware Kit
0407109
0406829 27mm x 27mm x 50mm angle brackets
(Used to attach modesty panel/laminate legs to top) 8
0406711 #10 x ¾” square pan screws
(Used to attach the angle brackets) 32
0406900 ¼-20x2.359” joint connector bolts
(Used to attach laminate legs to modesty panel) 8
0406509 Base Leveler M10 4
Conference Tables
With Laminate Legs
Part Identifier Key
HourglassBuckle
Boat Race Track
Rectangle