WE-EF PFL230 LED User manual

Safety Notice
The manufacturer is discharged from liability when damage
is caused by improper use or installation.
If any luminaire and/or accessory is subsequently modi-
fied, the persons responsible for the modification shall be
considered as manufacturer.
PFL230 LED_241121 / 006-1330
Technical specifications are subject to change.
© WE-EF 2022
we-ef.com
WE-EF LIGHTING USA
Tel [phone]
[email protected]
WE-EF LIGHTING
Installation and
Maintenance Instructions for
Post Mounted Luminaire
PFL230 LED

Post Mounted Luminaire
IP66, IK08
PFL230
9.84
16.14
5.51
Light source
12 LED 12W / 18 LED 18W / 12 LED 24W / 18 LED
36W*
* Nominal power, for latest data refer to
www.we-ef.com
Class I, II, ta = 25 °C
Mounting height ...................................... 11.5 – 20 ft
Weight .............................................................. 21.2 lb
Windage area ...................................... max. 0.452 ft²
Ø0.217 – 0.472 in 16 AWG
120-
277 V
Installation
The product must be installed and maintained by
a suitably qualified professional in compliance with
latest building/construction and/or electrical regu-
lations and relevant legislation.
Attention: Do not open luminaire while mains
supply is switched on.
Notice: If the luminaire is modified by anybody
other than the original manufacturer, then the
warranty will no longer be valid and shall become
the full responsibility of the modifying person/
organisation. Claims based on defects attributable
to improper installation and/or application, and the
consequences thereof, are excluded.
In case of component failure, LED replacement
due to abnormal circumstances or at end of life,
replacement must be carried out by a suitably qua-
lified and trained professional.
In case of questions please contact our technical
hotline: [phone] (from Monday - Friday
from 08.00 until 16.00 hours).
Maintenance
Apart from cleaning the product’s exterior surfaces,
no special maintenance work is required. Do not
use high-pressure cleaners.
Protect our environment: Discard used LEDs in
compliance with the most recent environmental
legislation.
Installation Procedure
1) Switch off the mains electrical supply.
Notice
In case the luminaire is equipped with an optional
available surge protector, the function can get
tested if the signal LED is lit green when the supply
voltage is turned on.
In case the surge protector is defective, the LED
device gets automatically disconnected from the
mains supply. If the signal LED is not lit, the lumin-
aire is not functioning.

A
B
2) Loosen screws Band open frame A.
D
C
3) Unlock shutter Cand turn down the gear-tray,
disconnect plug connector Dand remove the
gear-tray.
4) Cut the connecting cable Xcorresponding to
the height of the pole and insert it via the bra-
cket Ethrough the cable gland Finside the
luminaire. Connect the neutral conductor (N),
phase (L1) and the earthing to the corres-
ponding marked contacts of the terminal
clamp D.
Class II: No protection earth is required. The
power cable has to be double insulated accor-
ding to class II.
X
F
E
G
5) Firmly tighten cable gland F, fasten the conduit
and install the bracket Eto the luminaire.
6) Put in gear-tray, close plug connection Dan
close the gear-tray. Make sure that the gear-
tray is firmly shut.
7) Close frame Aand firmly tighten screws B.
8) Feed cable through top of column, while setting
luminaire in position. Secure luminaire by evenly
tightening the six hexagon socket screws G.