Weinmann SOMNOvent CR User manual

SOMNO vent CR
CS-Therapy unit with autoTriLevel principle
SOMNO vent CR
SOMNO vent CR with SOMNO click 300
Short instructions for use
with devices as of serial number 10.000
or firmware version 5.0

3
EN
These short instructions summarize the most important points for the
use of SOMNO vent CR. More detailed information can be found in the
complete operating instructions WM 66321. In particular, please note
the convenient operation using the patients' menu.
Switching the unit on/off
Operation without humidifier
Switch the unit on/off
Status: Device switched off

Remove the humidifier

Connect the breathing tube

Switch on device
Display: Therapy Pressure

4EN
Operation with humidifier
Status: Device switched off

Open the filling plug;
fill with water up to the mark
"";
close the filling plug

Detach the breathing tube

Push on the humidifier

Push on the breathing tube

Switch on device

5
EN
Adjusting the humidifier level
Mask test
Display: Therapy Pressure

Switch on humidifier
Display: Humidifier in
operation, humidifier level set
Status: Device switched on

Hold pressed down for 3
seconds until the humidifier
level flashes in the display
Display: Humidifier level
flashes

Set level: + or -
Status: Device switched off

Press Menu key briefly 3x .
or

6EN
Leakage indicator
Softstart
Display: pressure for mask test
flashes

Change by means of + or -
Status: Device switched on

Press Menu key briefly 1x .
Display: No/small leak.
Display: Medium leak.
Fit the mask.
Display: Medium leak.
Fit the mask.
Status: Device switched on

Switch the Softstart on or off
Display: Softstart activated
or

7
EN
Adjusting the Softstart time
Automatic switching of the device
Auto 0FF = Automatic deactivated
Auto on = Automatic activated
Status: Device switched on
Hold pressed down for
3 seconds until the display
flashes
Display: Softstart time flashes
Set time: +or -
or
Status: Device switched off
Press the menu button 2x
briefly
Display: Current Setting
Change with +or -
or

8EN
Reading out the therapy data
Overall length of therapy
Length of day's therapy
Operating hours
Drying the tube system
Switch on device
Switch off device
Switch off the device, press
the button for a long period
Status: Device switched off
Thoroughly shake out the
still-damp breathing tube
Remove the humidifier if
necessary

9
EN
Display

Connect the breathing tube
alternatively,
if there is moisture in the
pressure measuring tube, plug
the red drying adapter
between the device outlet
port and the breathing tube.
Start the drying process: press
at the same time briefly.
Interrupt the drying process
Filter change necessary
Servicing necessary
and