Winners Only DP54278 User manual

DP54278- ( B )
DP54278- ( C )
PAGE 1 OF 2 MADE IN MALAYSIA
TBS-11374-TGNWU
WINNERS ONLY
HARDWARE LIST:
Flat Washer
Wrench
Lock Washer
Hex Nut 5/16"
5/16"
M8.5 x 18 x 1.2mm
12.8 mm
8 pcs
8 pcs
8 pcs
1 pce
1
2
3
This product will take 15-20
minutes to assemble.
Table Top
Leg
NO
COMPONENT LIST:
SKETCH
DESCRIPTION QTY
1 pce
4 pce
Hardware Bag 1 pack
A
B
C
NO SKETCHSIZE
DESCRIPTION QTY
Screw driver is require for assembly (not included)
TIP:store the Allen key and or Wrench used in assembly
in this product’s drawer or use masking or painter’s tape
to affix it to the underside of the product .this will make it
easier to find if you want to periodically tighten bolts or
disassemble the product.
PROD . NO: DP54278
Thank you for purchasing this quality product. Please read the instructions thoroughly before unpacking the
assembly parts.
Caution: Sharp exposed staple tips can cause injury, therefore for your protection, please remove
any exposed staples used in packing.
Please keep all hardware parts out of the reach of children.
1.We recommend that you should assemble this product with the assistance of another person: this will make the
assembly easier,and will help to prevent personal injury and to insure parts are not damaged during the
assembly process.
2.Before beginning,please check the packing materials carefully for small parts which may have come loose
inside the carton during shipping. Please do not discard any packing material until all parts have been located.
If any parts are missing, please contact your dealer for prompt replacement.
3.To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for stain residues
and rough surfaces and also check for staples or nails left after removing the packing materials. The manufacturer
will not be held responsible if preventive steps are not taken prior to installation.
4. Please do not over tighten screws or bolts. During normal use everyday,screws,bolts,nuts and wooden plugs
may loosen up. They should be periodically inspected and re-tightened to prevent damage to the furniture
and (or) personal property of cause injury. Always check to be sure all harware on this list and the below
mentioned components are attached to the furniture properly and kept tightened.
5.Please lay all parts and hardware on a non abrasive surface such as a carpet,and follow the assembly.
4

2) Unlock the metal catches underneath the table and pull the table top wide open equally from both ends. Lift both leaves from the
compartment.
3) Flip up the aprons, unfold leaf and place the leaf on the Table Top surface carefully.
4) Push table top from both ends to close. Lock the metal catches underneath the table.
ASSEMBLY
1) Turn the Table Top upside down on a protective
surface such as carpet or other soft material.
Place the leg to corner of Apron, then tighten the
Flat Washer,Lock Washer and Hex Nut using the
Wrench provided. Repeat the same for the other
legs.Set the Table upright on its legs.
2
4
3
Wrench
Flat Washer
Hex Nut
Lock Washer
Flip up Apron
Unlock
Metal Catches
PAGE 2 OF 2 MADE IN MALAYSIA
TBS-11374-TGNWU
DP54278
WINNERS ONLY
CARE INSTRUCTION
~ Be sure to use the same type of polish consistenly.
Your furniture will appear cloudy or streaky if oil
based or wax based polishes are interchanged.
~ Spray your furniture surface evenly. Wipe in a
circular motion with a soft clean cloth.
Lock
Metal Catches