WMF 9000F Instructions for use

µ
WMF coffeemachines
WMF Grounds Separator planning information for
WMF 9000 F
http://www.wmf-kaffeemaschinen.de/fachplaner
WMF Group GmbH | Eberhardstraße 35 |73312 Geislingen (Steige)
On site
3x1mm2,
length appr.
1.5 m
40 adjustable
Mounted vertically
40 adjustable
Mounted in a hanging position
adjustable

µ
WMF coffeemachines
WMF Grounds Separator planning information for
WMF 9000 F
Dimensions
and empty
weight
Width
Height
Depth
Capacity
Weight
314mm
605mm
427mm
Approx. 12liter
Approx. 12kg
Installation
Clearance
For operating, service, and safety reasons the machine should be installed with a clearance
from the building or non-WMF components of not less than 50 mm at the sides and the back
wall. Clearance of at least 20 mm above the grounds separator is recommended. The height
of the installation surface above the floor is at least 850 mm. If the coffee machine
connections are to be run downwards through the counter, please make space for the lines,
which can reduce the usable space below the machine. Additional space for grounds through
counter need to be considered on site if necessary.
Installation
surface /
water spray
The device must be placed and leveled on a horizontal, sturdy, water-resistant, and heatproof
base. The device must not be cleaned using a water jet. The device must be installed where it
is protected against water spray. The device must not be located on a surface that is sprayed
or cleaned with a water hose, steam jets, steam cleaner, or similar devices.
Installation
information
Suitable for vertical mounted and hanging installation. Only to be installed with pipe siphon.
Due to the adjustable feet the grounds separator can be adjusted to a minimum of 579 mm
and maxmium 695 mm height depeding on the position and heigth of the siphon or drain
Ventilation of
base cabinet
In order to avoid moisture an adequate ventilation must be provided when installing the
grounds separator in the base cabinets (ventilation slots, holes). Air inlet at the lowest point
and highest point of the cabinet each need to have 5 dm² surface.
The separator need to be installed between the air inlet and outlet
Water supply
rinsing water
The rinsing water inlet must come from the coffee machine
Water
drainage
The drainage should be provided on site and connected to a pipe or hose with minimum 1 ½“
(DN40) with a minimum downward slope of 2cm/m. The odor trap need to be a pipe siphon. If
the siphon is not directly located under the drain pan and drainage conditions are not in an
optimal way a ventilation between grounds separator and pipe siphon is recommended.
http://www.wmf-kaffeemaschinen.de/fachplaner
WMF Group GmbH | Eberhardstraße 35 |73312 Geislingen (Steige)
For more information as the instruction manual , safety data sheets and certificates , see:
http://mediacenter.wmf.com/servicecenter/
All information refers to coffee machines/ equipment as standard version. Individual solutions can differ from the
standard version.