
Introduction
About This Quick Start Guide
Introduction 2122_050918 1-1
1
SECTION 1 INTRODUCTION
1.1 About This Quick Start Guide
CAUTION! This Quick Start Guide does not replace the need to read the manuals. This is only a guide to remind
you of the basics involved with owning and operating your setter.
This Quick Start Guide is designed to serve as a reminder of the basic contents of the
manuals. It is assumed that you have read the Operator’s Manual and understood the
safety notices that go with the individual sections. Deeper explanations of each operation
are found in the manuals.
NOTE: Optional equipment may appear in the illustrations.
1.2 Safety
The following symbols and signal words call your attention to instructions concerning your personal safety. Be
sure to observe and follow these instructions.
DANGER! indicates an imminently hazardous situation which, if not avoided, will result in serious injury or death.
WARNING! suggests a potentially hazardous situation which, if not avoided, could result in serious injury or death.
CAUTION! refers to potentially hazardous situations which, if not avoided, may result in minor or moderate injury or
damage to equipment.
IMPORTANT! indicates vital information.
Read and observe all safety instructions before operating this equipment! Also read any additional manufacturer’s
manuals and observe any applicable safety instructions including dangers, warnings, and cautions.
Always be sure that all safety decals are clean and readable. Replace all damaged safety decals to prevent
personal injury or damage to the equipment. Contact your local distributor, or call your Customer Service
Representative to order more decals.
Electrical Safety (Optional Auto Feed Only)
DANGER! Make sure all electrical installation, service and/or maintenance work is performed by a qualified electri-
cian and is in accordance with applicable electrical codes.
DANGER! HAZARDOUS VOLTAGE can cause shock, burns, or death. SHUT OFF & LOCK OUT POWER before
performing service in any area of this machine. DO NOT restore power until all access panels are replaced and
secured.
WARNING! Always turn off and disconnect power at control console AND at main supply circuit breaker before per-
forming any service to the machine.