3 ft
3.5 in 3.5 in
1. Mark dimensions for mounting 2. Drill out holes for bracers and
power feed
TurnOFFpowersource before
installation
7. Snap feeder clip into track
9. Screw the track onto the
bracket from underneath
10. Check the position of the screws
as shown
8. Secure the R-LINE plate to the
track using set screws and allen
wrench
6. Threadfeeder throughhole in
ceiling
conduit wire
(provided by others)
5. Insert feeder though opening at
the end of the track
11. Insert linear connector(s)
12. Attach adjacent connector
to the track
13. Use screws to secure connector
from underneath
4. Use wood screws and washers
to secure brackets.
(Repeat steps 1 -4 for each individual channel)
3. Insert anchors
14. If not horizontally flush with the
ceiling, use the right screw to
level the track with the ceiling.
CORRECT
INCORRECT
