ZAPTEC Go User manual

Quick Guide
User
Zaptec Go
Start your
adventure today

Zaptec Go
works with any car
No matter what you drive or where you’re going,
Zaptec Go is the surest way to power your
journey. Built on leading edge Norwegian green
tech, we’ve created the world’s smallest 22 kW
(that’s max power) charger, that’s as smart on
the inside as it is simple on the outside.

3
Get to know your Zaptec Go
Status light
Type 2 socket
Charge card
authentication (RFID)

4
White Standby / Finished charging
Blue Charging
Green Eco Mode
Yellow Need authentication (App/RFID)
Red Error detected
Orange Not configured by electrician
Status light indicator

5
Connect your charging station to the Zaptec App
You need to connect the new charging station to the Zaptec App to
monitor your charging station, enable smart functions and manage your
Zaptec Go+ subscription.
Scan the QR code located on the front of the charging station to start.
1

6
Start / Stop charging
To start charging - Connect your charging cable to the vehicle and then
connect the charging cable to the charging station. The car is charging
when the status light changes to pulsating blue.
To stop charging - Please unlock and disconnect the charging cable from
the car before disconnecting the cable from the charging station. The
charging cable remains locked at the charging station until the charging
process is finished or stopped by the car.
2

7
Important information
Before using or maintaining this product, it is important to read the following safety
instructions. Failure to follow and apply all the instructions and procedures covered
in this quick guide will invalidate the warranty and cause Zaptec Charger AS and
direct partners to waive all liability and claims for compensation.
WARNING!
! Read the instructions carefully and familiarize yourself with the products before
installing or using the products.
! This product must only be installed, serviced, and repaired by qualified personnel. A
Zaptec certified partner shall carry out the handling of defect products under warranty.
!All applicable local laws and regulations must be followed during the installation and/
or service of the product.
! Do not install or use a product which is damaged in any way.
!Only use appropriate and certified installation materials for the installation.
!Do not insert foreign objects in the products outlets during voltage and insulation tests
as well as after the installation has been carried out. Measurements to be performed
according to the installation instructions for the product.
!Do not use high-pressure washer equipment on the products.
!Avoid installing the products in locations exposed to high temperatures.
!EVSE adapter is possible to use with the product; however, usage must comply with
local laws and regulations and resides outside the product specification and warranty.
!Charging cable extensions are not allowed to be used with this product.

© Zaptec Charger AS 27.01.2021. All rights reserved. ZM000724-1
Zaptec Charger AS
Richard Johnsensgate 4
4021 Stavanger
Norway
Made in Norway
zaptec.com
Zaptec