ZAPTEC Go User manual

Zaptec Go
Zaptec
Smart, small
and safe
Quick Guide
Installer

Zaptec Go
Zaptec
Smart, small
and safe

3
Get to know Zaptec Go
Status light
Type 2 socket
Charge card
authentication (RFID)

4
Included in the box:
3x Sealing cones 1 x Cable clamp
User manual
4x TX20
C
A
B
2x TX20 2x TX20
Remove Front Cover
1
C

5
Mount the charging station
Make sure it’s level and at an appropriate height.
2
A
Place the power cable
Choose between three entry
options (top, back and bottom).
Punch out the knockout tab to
install from 1 or 2.
Each charging station must be
protected by a max. 40A Type A
30mA RCD circuit breaker.
3
3
1
2

6
Secure cable
Prevent cable from being dislocated by using the cable clamp
and screws. Use the sealing cones to make the installation
water resistant.
4
B
PE N L1 L2 L3 PE N L1 L2 L3 PE L1 L2 L3 PE L1 L2
Electrical connection
Connect all wires and firmly press down all levers as illustrated.
Then turn on the circuit breaker to continue.
5
TN 3-phase TN 1-phase IT 1-phaseIT 3-phase
PE N L1 L2 L3 PE N L1 L2 L3 PE L1 L2 L3 PE L1 L2

7
Configure charging station
Scan the QR code with camera and complete the installation
in the Zaptec App.
6
It is possible to configure the charging station without using the
app, please note there might be limited functionality doing so.
Switch is located above the connection terminal.
Switch configurations:
1 - 6 Amps
2 - 10 Amps
3 - 13 Amps
4 - 16 Amps
5 - 20 Amps
6 - 25 Amps
7 - 32 Amps
8 - Not in use
9 - Not in use
0 - Unconfigured or
configured with App

8
Confirm green light
Configuration is completed when the charging station status
indicator changes to flashing green and then turns to white
status indicator.
7
Mount the Front Cover
Secure and lock the front cover.
8
C

© Zaptec Charger AS 27.01.2021. All rights reserved. ZM000692-1
Zaptec Charger AS
Richard Johnsensgate 4
4021 Stavanger
Norway
Made in Norway
zaptec.com