ZKTeco DL30B User manual

Installation Guide
Version: 1.1
Date: July,2017
DL30B Digital Lock with Voice Guide Feature

Before Installation
Diagram
M
1
K
A
B
C
D
E
F
G
H
C
I
J
N
L

A
H
E
L
M
J
H
E
L
M
J
G
F
K
Packing List
B
D
CI
2
N
Mounting Hardware Package Mounting Hardware Package
for door thickness of 30-38mm for door thickness of 39-46mm
56mm 6 4mm
25mm 35mm
20mm 30mm

Door Preparation
Note: Please refer to the above picture to adjust the direction of strike plate F and latch D.
1. Check the door thickness and prepare the corresponding mounting
hardware package.
2. Check door opening direction.
30~38 56 20 10 25
39~46 64 30 10 35
47~54 72 35 10 40
55~60 80 45 10 50
H Spindle Length
(mm)
J Screw Length
(mm)
M Screw Length
(mm)
L Screw Length
(mm)
Door Thickness
(mm)
3
Left inward Right inward
Left outward Right outward
F
FF
F
D
DD
D
Note: The standard lock includes 2 mounting hardware packages only, which are used for the door
thickness of 30-38mm and 39-46mm separately.

70mm 60mm
3. Check the required backset (60mm or 70mm).
Note 1: Installation template has the backset
options of both 60mm and 70mm.
4
60mm70mm 60mm
2-3/4 2-3/8
2-3/4 2-3/4
2-3/ 8
70mm
60mm
Note 2: The latch has two backset options: 60mm and
70mm, please choose either one as required.

Hexagon Screw
Remarks
1. New lock is configured to grant any password or card access.
2. The lock is equipped with mechanical keys for manual unlocking. Remove mechanical keys from the
package and keep them in a safe place.
3. To power up the lock, four alkaline AA batteries (not included) are required. Non-alkaline and
rechargeable batteries are NOT recommended.
4. The operation of lock setting has a stand-by time limit of 10 seconds; if there is no any activity, the lock
will shut off after 10 seconds.
N
A
How To Use Mechanical Key And Change Handle Direction?
5

Note 1: Align the template along the vertical center
line of the latch(D) at the desired handle height,
and tape it to the door.
Note 2: Mark the holes first, and then start drilling.
1. Drill holes on the door. 2. Install the latch (D).
E
E
D
center line of the
handle
desired handle
height
Installation
6

Correct Position: T he small triangle
must be vertically upward.
Incorrect position
3. Install outdoor unit (B) with gasket (C) and spindle(H) on the door.
B
H
C
7

4. Install mounting plate (I) with gasket (C) on the door.
J
5. Install indoor unit (K).
M
Note : Push cable into the hole first.
L
B
C
I
I
C
J
8

58mm
(5/64")
35mm
14mm
29mm
21mm
12mm
2mm
6. Insert batteries.
EG
F
7. Mark and drill holes for the strike.
8. Test the lock by rotating the back handle and using the mechanical
key (A).
Note : When the door is l ocked and the clutch is idle, the front handle
can be turned, but the door will remain locked.
9
(15/32")
(53/64")
(35/64") (1-3/8")
(1-9/64")
(2-9/32")