zortrax M200 Use and care manual

Fuse Replacement
SOURCE:
https://support.zortrax.com/fuse-replacement/
page 1 / 8

Table Of Content
Unplugging the Power Cable 4
Fuse Plug Removal 5
Fuse Replacement 6
Inserting the Fuse Plug 7
Plugging the Power Cable 8
page 2 / 8

The fuse protects your printer from short circuits and power overload. It is placed
between the power outlet and the switch on the left side of the printer. If your
machine does not start after pressing the power switch, at first you should check
if the power cable is connected to a power source. Then, you should check if the
LED on the power supply unit is on. If the diode is lit, the fuse is probably blown
and needs to be replaced. Follow the instructions provided in this manual to see
the correct replacement procedure.
The following manual shows the M200 repair work. For the M300, M200 Plus and M300
Plus, these procedures are the same.
page 3 / 8

Unplugging the Power Cable
Turn off the machine and unplug the power cable. Wait a few minutes for all the
capacitors to discharge.
page 4 / 8

Fuse Plug Removal
Remove the fuse plug using a flathead screwdriver. The plug is placed next to the power
switch.
page 5 / 8

Fuse Replacement
Remove the old fuse and insert a new one: 250V F5AL 5 Amp.
page 6 / 8

Inserting the Fuse Plug
Insert the plug with the new fuse into the slot next to the power switch.
page 7 / 8

Plugging the Power Cable
Plug the power cable in.
Powered by TCPDF (www.tcpdf.org)
page 8 / 8