zortrax M200 User manual

Packing
SOURCE:
https://support.zortrax.com/m200-packing/

Table Of Content
Unplugging the Power Cable 3
Unplugging the Extruder Cable 4
Removing the Platform 5
Lifting the Heatbed Mount 6
Placing the Starter Kit Box 7
Placing the Accesories Foam 8
Setting the Extruder in the Right Position 9
Placing the Fillers 10
Wrapping the Printer 11
Placing the Bottom Cushioning 12
Putting the Printer in the Box 13
Placing the Top Cushioning 14
Packing the Printer 15
Taping the Box 16

Unplugging the Power Cable
Turn the printer off, unplug the power cable and wait until the printer cools down.

Unplugging the Extruder Cable
Unplug the extruder cable.

Removing the Platform
Unplug the heatbed cable. Both big and small connectors need to be unplugged.
Remove the platform from the printer.

Lifting the Heatbed Mount
Lift the heatbed mount.

Placing the Starter Kit Box
Put the platform into the Starter Kit box and place the box on the bottom of the printer.

Placing the Accesories Foam
Place the printer accessories in the accessories foam. Put the foam with the accessories
on the Starter Kit box inside the printer, then lower the heatbed mount so that the box
and the foam are tightly secured.

Setting the Extruder in the Right Position
Move the extruder manually to the back right corner of the printer. Secure the extruder
with the shipping clips.

Placing the Fillers
Place the fillers on the foam.