zortrax M200 Use and care manual

Display Panel Replacement
SOURCE:
https://support.zortrax.com/m-series-display-panel-replacement/
page 1 / 13

Table Of Content
Unplugging the Power Cable 4
SD Card Removal 5
Unscrewing the Display Panel 6
Display Panel Back Cover Removal 7
Display Panel Removal 8
Connecting the Display Panel 9
Display Panel Installation 10
Securing the Display Panel 11
Inserting the SD Card 12
Plugging the Power Cable 13
page 2 / 13

The display panel consists of a high contrast screen and a round, rotating knob.
The screen displays information about the current printing process, the printer’s
menu, and other information concerning the printer. The knob allows you to
navigate through the printer’s menu, and adjust and control its basic settings.
Therefore, if there is nothing displayed on the screen or the knob does not work
properly (it rotates with resistance or becomes too loose), the display panel needs
to be replaced. This manual shows the correct replacement procedure.
The following manual shows the M200 repair work. For the M300, these procedures are
the same.
page 3 / 13

Unplugging the Power Cable
Turn off the printer and unplug the power cable.
page 4 / 13

SD Card Removal
Remove the SD card from the slot.
page 5 / 13

Unscrewing the Display Panel
Unscrew the four screws that secure the panel to the front frame of the printer
page 6 / 13

Display Panel Back Cover Removal
Carefully separate the back cover from the front frame.
page 7 / 13

Display Panel Removal
Unplug the display connector and remove the display panel.
page 8 / 13

Connecting the Display Panel
Connect the new display panel.
page 9 / 13

Display Panel Installation
Install the display panel with the back cover.
page 10 / 13