zortrax M200 User manual

Power Switch Replacement
SOURCE:
https://support.zortrax.com/power-switch-replacement/
page 1 / 19

Table Of Content
Unplugging the Power Cable 4
Changing the Printer's Position 5
Unscrewing the Bottom Plate, part 1 6
Turning the Printer 7
Unscrewing the Bottom Plate, part 2 8
Separating the Bottom Plate 9
Unscrewing the Power Switch 10
Power Switch Removal 11
Power Switch Installation 12
Securing the Power Switch 13
Bottom Plate Installation 14
Securing the Bottom Plate, part 1 15
Turning the Printer 16
Securing the Bottom Plate, part 2 17
Changing the Printer's Position 18
Plugging the Power Cable 19
page 2 / 19

The power switch is placed on the left side of the printer and allows you to turn on
and off the power supply. If your machine does not start after pressing the power
switch, at first you should check if the LED on the power supply unit is on. If the
diode is lit, check if the fuse is not blown. If you’ve checked these components
and everything seems to be working properly, the power switch is probably
broken. Follow the instructions provided in this manual to see the correct
replacement procedure.
The following manual shows the M200 repair work. For the M300, M200 Plus and M300
Plus, these procedures are the same.
page 3 / 19

Unplugging the Power Cable
Turn off the machine and unplug the power cable. Wait a few minutes for all the
capacitors to discharge.
page 4 / 19

Changing the Printer's Position
Grab the printer’s housing and change the printer’s position so that you can easily
access the bottom plate.
page 5 / 19

Unscrewing the Bottom Plate, part 1
Unscrew the screws that secure the bottom plate on one side of the housing. Use a
2.5mm Allen key.
page 6 / 19

Turning the Printer
Turn the printer over.
page 7 / 19

Unscrewing the Bottom Plate, part 2
Unscrew the screws that secure the bottom plate on the other side of the housing. Use
the same key.
page 8 / 19

Separating the Bottom Plate
Separate the bottom plate from the printer and unplug the bottom fan cable from the
motherboard.
page 9 / 19

Unscrewing the Power Switch
Unscrew the two screws that secure the power switch. Use a 2mm Allen key.
page 10 / 19