zortrax M200 User manual

Nozzle Cleaning
SOURCE:
https://support.zortrax.com/nozzle-cleaning/

Table Of Content
Scrubbing the Nozzle 3
Unclogging the Nozzle 4
Unloading the Material 5
Nozzle Removal 6
Unplugging the Power Cable 7
Cleaning the Nozzle 8
Removing the Nozzle from the Container 9
Nozzle Assembly 10

Scrubbing the Nozzle
Take the spatula from the Starter Kit and gently scrub the nozzle to remove material
remains.

Unclogging the Nozzle
From the menu choose “Material” and then “Load the material” option. Follow the
instructions displayed on the screen.
Use the pliers from the Starter Kit to hold a needle. As soon as the printer starts to load
the material, insert the end of the needle into the nozzle to unclog it.
If that doesn’t help, follow the rest of the steps from this manual.

Unloading the Material
From the menu choose “Material” and then “Unload the material” option. The extruder
should start to heat up automatically. Once the extruder is hot, the motor will start to
unload the material.

Nozzle Removal
Unscrew the nozzle counterclockwise (when viewed from below). Use the nozzle key
from the Starter Kit box. Removing the nozzle should take place while the extruder is still
hot. When the nozzle is loose, remove it using pliers.

Unplugging the Power Cable
Turn off the printer and unplug the power cable. Wait about 15 minutes and let the
machine cool down.

Cleaning the Nozzle
If you were printing with Z?GLASS / Z?PETG / Z?PCABS / Z-ESD, print a small-sized
object using Z?ABS. This will help to extrude material remains from the nozzle.
Using the pliers, place the nozzle in a container filled with acetone.
Make sure that the nozzle is cold before you put it into the container.

Removing the Nozzle from the Container
After 8-10 hours take the nozzle out of the container with pliers.

Nozzle Assembly
Install the nozzle in its place in the hotend and screw it in clockwise using the nozzle key
(when viewed from below).
Screw in the nozzle gently; do not use too much force.
Powered by TCPDF (www.tcpdf.org)