zortrax Inventure Instruction sheet

Preparation for the First Use of
Inventure
SOURCE:
https://support.zortrax.com/preparation-for-the-first-use-of-inventure/

Table Of Content
Preparing your Printer to Work 3
Z-Firmware Installation 11
Z-SUITE Installation 12
Cartridge Installation 13
First Print 16

Preparing your Printer to Work
Open the box and remove the cushioning.
Remove the boxes with accessories.

Use the handles to take the printer out of the box. The handles are on both sides of the
housing.
Remove the security foil.

Open the top door and remove the plastic foams holding the extruder.
Insert the build tray into the printer and turn the safety locks by 90?. Close the front door.

Plug in the power cable and turn on the printer.
From the menu choose “Material,” then “Model” and “Load the model material.” Follow
the instructions provided on the display.

Open the left door by pressing the release buttons.
Insert the model material cartridge on the left side of the printer and turn the lock to
CLOSE. Close the side door.

From the menu choose “Material,” then “Support” and “Load the support material.”
Follow the instructions provided on the display.
Open the right door by pressing the release buttons.

Insert the support material cartridge on the right side of the printer and turn the lock to
CLOSE. Close the side door.
From the menu choose “Maintenance” and then “Platform Leveling.” Follow the
instructions provided on the display.

From the menu choose “Maintenance” and then “Nozzle Alignment Calibration.” Follow
the instructions provided on the display.