zortrax Inkspire User manual

Unpacking & First Use
SOURCE:
https://support.zortrax.com/unpacking-first-use/

Table Of Content
In the Box 3
Preparing the Printer for Work 4
Printing and Post-Processing 12
Firmware Update 23

In the Box
The graphic shows the whole box content.

Preparing the Printer for Work
Open the box and remove the upper cushioning.
Remove the UV cover.

Remove the Starter Kit and the foam with the bottle of resin.

Take the printer out of the box. Don't grab the Z-axis screw when lifting the printer.
Remove the foil.

Place the printer on a flat and stable surface.
If the printer remains uneven, use the plastic wrench from the Starter Kit to tighten or
loosen the printer's legs as needed.

Move up the platform by gripping the platform block and pulling it upward (A). Remove
the cushioning (B).
Clean the FEP film inside the resin tank with a cloth.

Remove the foil from the UV cover. Install the UV cover on the printer. The cover's seam
should be placed behind the Z-axis.

Plug in the power cable and turn on the printer. Connect it to a network via Wi-Fi or
Ethernet. Go to Settings and configure the connection using options from the menu.
To calibrate the platform, select Tools -> Calibration. Follow the instructions displayed
on the screen.