zortrax M200 Plus Instruction sheet

First Use Preparations
SOURCE:
https://support.zortrax.com/preparation-first-use/

Table Of Content
Prepare your Printer to Work 3
Z-Firmware Update 13
Z-SUITE Software Installation 14
Loading the Material 15
First Print 18

Prepare your Printer to Work
Open the box and remove the upper cushioning.
Take the 3D printer out of the box. When lifting or moving the printer, do not grab:

Abelts
Bshipping clips
Cextruder
Remove the foil.

Remove one side cover – either left or right.
Remove the fillers.
Remove the shipping clips.

Remove the foam with accessories and the Starter Kit box.
Lower the heatbed mount by pressing the places marked in the picture.

Install the side cover.
Install the build platform onto the bolts marked in the picture. Remember to install the
platform with the perforated plate and its five silver calibration squares directed up.

Connect the platform cable.
Install the extruder cable clamps in the holes at the back of the printer. Place the
extruder cable in the clamps.

Remove the extruder top cover and plug in the extruder cable.
Plug in the power cable.

Attach the material guide to the extruder and to the material endstop.
Attach the spool holder to the back of the printer. The holder can be opened with the
push-to-open mechanism. Place the material spool onto the fixed part of the holder and
press the other part until you hear a click. The spool should rotate anti-clockwise.

Feed the material into the extruder through the material endstop and the material guide.
To install the firmware in your printer, download the latest firmware version from
support.zortrax.com/downloads. Transfer the Update.zar file to a USB flash drive and
plug it into the port at the front of the device. To start the installation, select Refresh.

To calibrate the platform, select “TOOLS,” “PLATFORM” and then “CALIBRATE” from
the menu. Follow the instructions displayed on the screen.

Z-Firmware Update
If your printer is connected to the Internet using either Wi-Fi or an Ethernet cable, it
automatically checks for available firmware updates every time you turn it on.
If the firmware needs to be updated, follow the instructions displayed on the screen.

Z-SUITE Software Installation
The latest Z-SUITE update can be found at the Zortrax Support Center in the Downloads
section.
To download and install Z-SUITE, you need enter the serial number of your printer. The
serial number can be found in the printer’s menu: Settings -> About Printer, and on the
nameplate at the back of the printer.

Loading the Material
To load the material, select “Material” and “Load material” from the Tools menu. Next,
select the type of material which you are going to use.
Follow the instructions displayed on the screen.
Once the printer finishes loading the material, it is ready to print. Remove material
remains using tweezers.

First Print
To choose the model for printing, open the Models menu.
Select the model in the .zcodex format and tap the Print button.
Next, the printer will start to heat up. Once the heating is completed, the printing process
will start automatically. The screen will show the progress of the print.
Do not leave the printer unattended during the pre-print calibration.

Powered by TCPDF (www.tcpdf.org)