zortrax M300 Plus Instruction sheet

Unpacking & First Use
SOURCE:
https://support.zortrax.com/m300-plus-unpacking-first-use/

Table Of Content
In the Box 3
Unpacking 4
Setting Up 9
Firmware Update 16
Z-SUITE Installation 17
Material Loading 18
First Print 21

In the Box
The graphic shows the whole box content.

Unpacking
Open the box and remove the upper cushioning.
Take the printer out of the box*. When lifting or moving the printer, do not grab:

A.belts
B.shipping clips
C.extruder
*Due to the printer's weight, the Zortrax M300 Plus should be taken out of the box or
moved by two people.
Place the 3D printer on a flat and stable surface.

Remove the foil and fillers.

Remove the protection elements (shipping clips and safety belt).
Remove the foam with accessories.

Lower the heatbed mount by pressing the places marked in the graphic.

Setting Up
Install the build platform onto the bolts marked in the graphic. Remember to install the
platform with the perforated plate with its silver calibration squares directed up.

Plug the heatbed cable into the platform and into the adapter placed in the Z-axis cover.
Plug in the perforated plate small cable as well.
Install the extruder cable clamps in the holes at the back of the printer. Place the
extruder cable in the clamps.