zortrax Z-PLA Pro Assembly instructions

Tips for Printing with Z-PLA Pro
SOURCE:
https://support.zortrax.com/z-pla-pro-tips/

Table Of Content
Hotend Requirements 3
Extruder Upper Fan Operation 4
Platform Calibration Requirements 5
Temperature Tips 6
Leaving the Model on the Platform 7

Hotend Requirements
Use a separate hotend that will be dedicated only for printing with Z-PLA Pro. The
hotend should be new and not used with other materials during different projects.
Unload Z-PLA Pro from the hotend immediately after the printing process. Do not keep
the overheated material loaded in the extruder to avoid material degradation in the
nozzle.

Extruder Upper Fan Operation
Check if the extruder upper fan is operating properly. A faulty fan can cause Z-PLA Pro
to overheat which can have a negative influence on the printing process.
Also, use compressed air to clean the extruder upper fan and its heat sink from dust.

Platform Calibration Requirements
You should calibrate the platform before loading Z-PLA Pro into the hotend – the
extruder needs to be empty during the procedure. The nozzle becomes very hot during
the calibration and it could cause the material to overheat which can bring poor printing
results.

Temperature Tips
Remove the side covers before using Z-PLA Pro. This material is sensitive to high
temperatures so the recommended temperature in the print room is below 25° C [77°
F].

Leaving the Model on the Platform
Once the printing process has been finished, leave the model on the platform for about
30 minutes to let it cool off. This will make it easier for you to remove your print from the
platform. Also, you will be able to remove the raft and support structures from the model
more easily.
Powered by TCPDF (www.tcpdf.org)