AAQ AutoLift AL-2525 User manual

Advance AutoQuip
2 McDonald Crescent | Bassendean WA 6054
Ph: 08 9279 1663 | Fax: [phone] | E: [email protected] | W: www.aaq.net.au
- READ THE ENTIRE CONTENTS OF THIS MANUAL BEFORE
INSTALLATION AND OPERATION. BY PROCEEDING YOU AGREE THAT
YOU FULLY UNDERSTAND AND COMPREHEND THE FULL CONTENTS
OF THIS MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS.
FAILURE TO OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE
INJURY OR DEATH.
Specifications subject to change without notice.
Note: While all due care and attention has been taken in the preparation of this document, Advance AutoQuip shall not be liable for any inaccuracies or omissions
which may occur therein
4 POST CAR STACKER
AutoLift AL-2525
Model No: HP-2525 / HP- 2625 Four Post, Three Car Stacker
2500Kg Capacity Lower Platform, 2000Kg Capacity Upper Platform
Design Registration Approval Number: N/A Domestic Application
Design Code: AS1418.9-1996
INSTALLATION MANUAL & OPERATION
INSTRUCTIONS
READ FIRST
DO NOT use the
machine until you read
and understand all the
dangers, warnings and
cautions in this manual.

ＣＡＴＡＬＯＧ
01
01
04
07
24
28
29
30
32
1. Safety instructions
2. Product overview
3. Site planning
4. Installation
5. Hydraulic & Electrical Diagrams
6. Operation
7. Surface Cleaning & Protection
8. Maintenance
9. Troubleshooting
AAQ Australia / Advance AutoQuip
Address: 2 McDonald Crescent
Bassendean, WA 6054 Australia
Website: www.aaq.net.au
Phone: [phone]
Email: [email protected]

１ Safety instructions
2.1.Introduction
AL-2525



２Product overview

you fully understand and comprehend the full contents of this manual. Forward this manual to all operator.
Failure 
1.1.Copyright. Copyright by Advance AutoQuip 2000. All rights reserved. You are not allowed to use the
copies for commercial purposes.
1.2.Usage. AutoLiftAL-2525on
top of each other for permanent parking or car storage, any other usages are to be considered improper,
thus highly forbidden.
1.3.Receiving. When receiving the cargos, please check the packaging carefully and thoroughly. Contact
sales person of Advance AutoQuip 2000 to verify the causes for any shortages or damages. Claims for material
damage shall be 
1.4.Warranty. 
refer to the end of this manual.
1.5.Installer. 

cranes, etc.
1.6.Protection.

1.7.Caution. Keep your hands and feet away from any moving parts.
1.8.Electrical. 

1.9.Owner. Owners shall make sure that all operators have been properly trained, knowing how to safely and
correctly operate the system.
1.10.Modify. 
1.11.Danger. 
1.12.Warning. 

1.13.Maintenance.
1.14.
! This mark means safety warning.
1.15.Liability. 

01
AL2525 & AL2625 USER MANUAL

This series contains two models:
AL-2525


AL-AL-2525

2.2.General parts
Note: 
 
1 Main post.
2 Front right post & rear left post
3 Rear right post.
4 Runways of lower platform
5 Cover plates on lower platform
6 Hydraulic cylinder
7 Power pack & electrical box
8 Operating panel (Key switch)
9 Crossbeam of lower platform
10 Runway of upper platform
11 Cover plates on upper platform
12 Cover plates of posts
13 Side beams
14 Anti-falling hook
15 Ramp
16 Wheel stopper
1
3
7
5
4
6
2
8
9
11
12
13
14
15
16
2
10
16
02
AL2525 & AL2625 USER MANUAL

2.3. Dimensions
Note: 
as-produced dimensions.
AUTOLIFT 2625
AUTOLIFT 2525
4550
2100 2100
2100
2492
2802
4309
5060
2100
2802
4966
1650
6096
2200
4549
1850 1600
2492
2802
4309
5060
2100 1650
5344
2100
2200
4216
2802
4549
03
AL2525 & AL2625 USER MANUAL

2.4.Operating conditions


purchase order.

-Ambient temperature: -15℃to +40℃
℃



℃to
55℃℃.
3.1 Select location
3.1.1
hoist
3.1.2 hoistAL-2525AL-

3.1.3 hoist

lines, etc., which could cause damage to the vehicles on top.
3.1.4 
3.1.5 
3.1.6 hoist
3.1.7 Advance AutoQuip 2000

3.2 Foundation treatment
3.2.1 
 
- Minimum thickness is 300mm, concrete grade C30 or above.
 
 
 
AL-2525
3.2.2 hoist
- Minimum concrete thickness is 200mm, concrete grade C30 or above;
 
 
３Site planning
04
AL2525 & AL2625 USER MANUAL

3.2.3 
3.2.4 Pre-embedded anchor bolts are not required.
3.2.5 

hoistAdvance AutoQuip 2000
caused by the above as a consequence.
3.3 Deciding the orientation
hoist.



 
4199
500
500
5399
4199
600 100
5399
500
500
Ground surface
!
Entrance Direction
05
AL2525 & AL2625 USER MANUAL


please turn the whole structure around, and interchange the ramps and wheel stoppers only.

side and close to the power pack that way. Otherwise, we strongly recommend to install as per the standard way

3.4 Drawing chalk lines
3.4.1
3.4.2
Power pack
Key switch
Power pack
Key switch
4561
3841
360
200
4546
4546
3964
2402
2492 2802
 
 
06
AL2525 & AL2625 USER MANUAL



process.
hoist
Advance
AutoQuip 200061 (08) 9279 1663
[email protected] 
4.1 Necessary tools
Note: .
4.2 Unloading and unpacking
When receiving the cargos, please check the packaging carefully and thoroughly. Contact sales person of Advance
AutoQuip 2000 to verify the causes for any shortages or damages. Claims for material damage shall be made
against the 

frames or any other packing materials.

Check the voltage and phase requirements showed on motor or carton of power pack.

4.3 Assembly

4.3.1
hoist




４ Installation


1 set of Allen wrench.




1 piece of electric portable drill
Insulated rubber tape


1 piece of hammer

1 piece of grease gun
1 piece of tapeline for 5M
Chalk lines
Two pieces of wood
!
!For orders and cases with special dimensions, please consult our local partners or Advance AutoQuip 2000
sales team to get the valid drawing to your order.
3.4.3
3.4.4
07
AL2525 & AL2625 USER MANUAL

 
 
Post #2
Post #3
#1 Main Post
Post #2
08
AL2525 & AL2625 USER MANUAL

4.3.2 Cross beams
4.3.2.1

4.3.2.2
inner side.
4.3.2.3

 Top view of posts and cross beams on ground
 



09
AL2525 & AL2625 USER MANUAL

4.3.3 Erect the posts
Erect the 4 posts and locate them precisely according to the chalk lines. And insert 2 diagonal anchor bolts for each


4.3.4


Le�
Right
Hydraulic cylinder
beneath
 anchor bolts at diagonal
 
!
10
AL2525 & AL2625 USER MANUAL

4.3.5

4.3.6


4.3.7

Edge towards inside
Le�
Right
Wheel stopper
 
!
11
AL2525 & AL2625 USER MANUAL

4.3.8 

4.3.9 Top cover plates


Top cover plate
Triangle lock
U-shaped hook
   
 


12
AL2525 & AL2625 USER MANUAL

4.3.10





Cylinder
beneath runway
Ramp
Main Post
Steel rope roller Big window*
beneath lock holes
Left Runway
Fix the rope by
2xNuts & washer
 
 Fasten steel ropes on post top
13
AL2525 & AL2625 USER MANUAL

4.3.11

temperature; for low temperature areas, #32 hydraulic oil is recommended.
 
 Mount power pack on Main Post
4.3.12 Power pack
Power pack is mounted on the Base
Plate of Main Post.
4.3.13

of power pack through a backboard.
14
AL2525 & AL2625 USER MANUAL

W5
4.3.15 Hydraulic oil lining



cable W5 shall be wrapped together with spiral cover.
4.3.14 Key switch
Key switch, also known as control
panel, is with key and emergency

post also, front side. Holes have
been reserved in factory.
 Key switch on front of Main Post
W15
 
W5
 Oil tube lining
15
AL2525 & AL2625 USER MANUAL

  
limit switch, color Blue

2200mm close to the baseplate for power pack.
4.3.16 Fasten all the bolts on the structure

4.3.17

holes have been drilled in factory.
The upper limit switch is around 4600mm high, close to the post top.
W3
W4
W4
16
AL2525 & AL2625 USER MANUAL

4.3.18 Wiring of electromagnets





W12
W11
W14
W13
W8
W6
W7
17
AL2525 & AL2625 USER MANUAL

W10
W1
W14 W1
Wiring details
 
4.3.19 Main power cable

be bundled together with Cable W14, and
are protected by aluminum cover.
W10
W4
W11
W14
Aluminum cover
18
AL2525 & AL2625 USER MANUAL