ABB FDNA-01 Installation manual

Options for ABB drives, converters and inverters
Quick installation and start-up guide
FDNA-01 DeviceNet adapter module
Safety instructions
WARNING! Obey the safety instructions. If you ignore them, injury or death, or damage to the
equipment can occur. See the user’s manual.
Mechanical installation
Electrical installation
Layout of the module
1. Pull out the lock.
2. Install the module carefully to an option
module slot of the drive. See the drive
hardware manual.
3. Push in the lock.
4. Tighten the screw to torque 0.8 N·m using
a Torx TX10 screwdriver.
WARNING! Do not use excessive force,
or leave the screw too loose. Over-
tightening can damage the screw or
module. A loose screw decreases the EMC
performance, and can even cause an operation
failure.
13
4

No. Description
1Lock
2 Mounting and grounding screw
3 Bus connector [X1]
4 Diagnostic LEDs
4
3
2
1

Start-up
When the module is connected to the drive, the drive control program sets the applicable parameters.
See the appropriate drive manual.
Basic parameter settings
To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par refresh.
Further information
Index Name Value
20.01 Ext1 commands Fieldbus A
22.11 Speed ref1 source FBA A ref 1
28.11 Frequency ref1 source FBA A ref 1
50.01 FBA A enable Enable (or select the option slot in which the module is installed).
This activates the communication module. The HOST LED becomes green.
50.02 FBA A comm loss func Fault
51.02 MAC ID Set the MAC ID number for the drive.
See the latest version of FDNA-01 DeviceNet adapter
module user's manual (3AFE68573360 [English]) in ABB
library (www.abb.com/drives/documents).
For more information on fieldbus options and protocols
provided by ABB Drives, see the fieldbus
communications web page
(new.abb.com/drives/connectivity/fieldbus-connectivity).
Pin allocation for [X1] Bus termination
The module does not provide bus termination. The DeviceNet
network should be terminated at both ends of the trunk cable with
a 121 ohm, ¼ W, 1% metal film resistor.
Connect the resistor between the two signal wires (CAN_H,
CAN_L) on the DeviceNet cable, as shown in this figure.
Pin Description
1 V- Network power supply
ground (0V DC)
2 CAN_L CAN_L bus line
3 SHLD Network cable shield
4 CAN_H CAN_H bus line
5 V+ Network power supply
source (24V DC)
12345
Node 1 Node n
121

CAN_H
CAN_L
Scanner
121

1%
Metal Film
1/4 W
1%
Metal Film
1/4 W
…
3AXD50000158515 Rev A (EN) 2017-11-23
FDNA-01 manual
Fieldbus communications web page