ABB FDNA-01 Installation manual

Safety instructions
WARNING! Obey the safety instructions of the drive. If you ignore them, injury or death, or
damage to the equipment can occur.
Mechanical installation
Electrical installation
Layout of the module
1. Pull out the lock.
2. Install the module carefully to an option
module slot of the drive. See the drive
hardware manual.
3. Push in the lock.
4. Tighten the screw to torque 0.8 N·m
using a Torx TX10 screwdriver.
13
4
WARNING! Do not use excessive force, or leave the screw too loose. Over-tightening can
damage the screw or module. A loose screw decreases the EMC performance, and can
cause an operation failure.
No. Description
1Lock
2 Mounting and grounding screw
3 Bus connector [X1]
4 Diagnostic LEDs

3
2
1
4
—
OPTIONS FOR ABB DRIVES
FDNA-01 DeviceNet adapter module
Quick installation and start-up guide

Start-up
To control the drive with the adapter module, set at least the basic parameters listed in the table
below. For full parameter descriptions, refer to the adapter module’s user manual or to the drive’s
firmware manual.
Basic parameter settings
To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par
refresh.
Further information
Pin allocation for [X1] Bus termination
The module does not provide bus termination. The DeviceNet
network should be terminated at both ends of the trunk cable with a
121 ohm, ¼ W, 1% metal film resistor.
Connect the resistor between the two signal wires (CAN_H, CAN_L)
on the DeviceNet cable, as shown in this figure.
Pin Description
1 V- Network power supply
ground (0V DC)
2 CAN_L CAN_L bus line
3 SHLD Network cable shield
4CAN_H CAN_Hbusline
5 V+ Network power supply
source (24V DC)
Index Name Value
20.01 Ext1 commands Fieldbus A
22.11 Speed ref1 source FBA A ref 1
28.11 Frequency ref1 source FBA A ref 1
50.01 FBA A enable Enable (or select the option slot in which the module is installed).
This activates the communication module. The HOST LED becomes green.
50.02 FBA A comm loss func Fault
51.02 MAC ID Set the MAC ID number for the drive.
See the latest version of FDNA-01 DeviceNet adapter module
user's manual (3AFE68573360 [English]) in ABB library
(www.abb.com/drives/documents).
For more information on ABB fieldbus options and protocols,
see the fieldbus communications web page
(new.abb.com/drives/connectivity/fieldbus-connectivity).
12345
Node 1 Node n
121

CAN_H
CAN_L
Scanner
121

1%
Metal Film
1/4 W
1%
Metal Film
1/4 W
…
FDNA-01 manual
Fieldbus communications web page
© Copyright 2023 ABB. All rights reserved.
Specifications subject to change without notice.
3AXD50000158515 Rev B (EN) 2023-01-25
abb.com/drives