ABB FENA-21 Installation manual

Options for ABB drives, converters and inverters
Quick installation and start-up guide
FENA-21 Ethernet adapter module
Safety instructions
WARNING! Obey the safety instructions. If you ignore them, injury or death, or damage to the
equipment can occur. See the user’s manual.
Mechanical installation
Electrical installation
Layout of the module
13
4
1. Pull out the lock.
2. Install the module carefully to an option
module slot of the drive. See the drive
hardware manual.
3. Push in the lock.
4. Tighten the screw to torque 0.8 N·m using
a Torx TX10 screwdriver.
WARNING! Do not use excessive force,
or leave the screw too loose. Over-
tightening can damage the screw or
module. A loose screw decreases the EMC
performance, and can even cause an operation
failure.
No. Description
1Lock
2 Mounting and grounding screw
3 RJ-45 connector [X1] to Ethernet
4 RJ-45 connector [X2] for chaining another module
5 Diagnostic LEDs
6 MAC ID
5
3
2
4
1
6

Start-up
When the module is connected to the drive, the drive control program sets the applicable parameters.
See the appropriate drive manual.
Basic parameter settings
Protocol-specific parameter settings
To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par refresh.
Further information
Index Name Value
20.01 Ext1 commands Fieldbus A
22.11 Speed ref1 source FBAAref 1
28.11 Frequency ref1 source FBAAref 1
50.01 FBAAenable Enable (or select the option slot in which the module is installed).
This activates the communication module. The HOST LED becomes green.
50.02 FBAAcomm loss func Fault
PROFINET IO Ethernet/IP
Index Name Value Index Name Value
51.02 Protocol/Profile PNIO ABB Pro 51.02 Protocol/Profile EIP AC/DC
51.04 IP configuration Static IP 51.04 IP configuration Set the IP address
according your network
configuration.
51.05...08 IP address 0.0.0.0 51.05...08 IP address
51.09 Subnet CIDR 0 51.09 Subnet CIDR
52.01 FBAA data in1 SW 16bit 51.23 Speed scale 128
52.02 FBAA data in2 Act 16bit
53.01 FBAA data out1 CW 16bit Modbus/TCP
53.02 FBAA data out2 Ref1 16bit Index Name Value
51.02 Protocol/Profile Modbus/TCP
51.04 IP configuration Set the IP address
according your network
configuration.
Connectivity configuration 51.05...08 IP address
To access the configuration web page:
1. Open a web browser and type the IP address of the
adapter module in the address field.
2. Log in with a user name (admin) and a password (The
last six digits of the MAC address of the adapter module,
in upper case letters, without hyphens. Eg, if MAC ID is
00-1C-01-00-2F-73, the password is 002F73).
51.09 Subnet CIDR
See the latest version of FENA-01/-11/-21 Ethernet adapter
module user’s manual (3AUA0000093568 [English]) in
ABB library (www.abb.com/drives/documents).
For more information on fieldbus options and protocols
provided by ABB Drives, see the fieldbus
communications web page
(new.abb.com/drives/connectivity/fieldbus-connectivity).
3AXD50000158522 Rev A (EN) 2017-11-23
FENA-01/-11/-21 manual
Fieldbus communications web page