ABB FENA-01 Installation manual

1
Safety instructions
WARNING! Obey the safety instructions. If you ignore them, injury or death, or damage to the
equipment can occur. See the user’s manual.
Mechanical installation
Electrical installation
Layout of the module
1
1. Pull out the lock.
2. Install the module carefully to an option module slot of
the drive. See the drive hardware manual.
3. Push in the lock.
4. Tighten the screw to torque 0.8 N·m using a Torx
TX10 screwdriver.
3
4
WARNING! Do not use excessive force, or leave the screw too loose. Over-tightening can damage
the screw or module. A loose screw decreases the EMC performance, and can even cause an
operation failure.
4
1
23
5
No. Description
1 Lock
2 Mounting and grounding screw
3 RJ-45 connector [X1] to Ethernet
4 Diagnostic LEDs
5MACID
—
OPTIONS FOR ABB DRIVES
FENA-01/-11 Ethernet adapter module
Quick installation and start-up guide

2
Start-up
When the module is connected to the drive, the drive control program sets the applicable parameters. See
the appropriate drive firmware manual.
Basic parameter settings
Protocol-specific parameter settings
To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par refresh.
Connectivity configuration
To access the configuration web page:
1. Open a web browser and type the IP address of the adapter module in the address field.
2. Log in with a user name (admin) and a password (The last six digits of the MAC address of the adapter
module, in upper case letters, without hyphens. Eg, if MAC ID is 00-1C-01-00-2F-73, the password is
002F73).
Further information
Index Name Value
20.01 Ext1 commands Fieldbus A
22.11 Speed ref1 source FBA A ref 1
28.11 Frequency ref1 source FBA A ref 1
50.01 FBA A enable Enable (or select the option slot in which the module is installed).
This activates the communication module. The HOST LED becomes green.
50.02 FBA A comm loss func Fault
PROFINET IO Ethernet/IP
Index Name Va lue Index Name Value
51.02 Protocol/Profile PNIO ABB Pro 51.02 Protocol/Profile EIP AC/DC
51.04 IP configuration Static IP 51.04 IP configuration Set the IP address
according your network
configuration.
51.05...08 IP address 0.0.0.0 51.05...08 IP address
51.09 Subnet CIDR 0 51.09 Subnet CIDR
52.01 FBA A data in1 SW 16bit 51.23 Speed scale 128
52.02 FBA A data in2 Act 16bit
53.01 FBA A data out1 CW 16bit Modbus/TCP
53.02 FBA A data out2 Ref1 16bit Index Name Value
51.02 Protocol/Profile Modbus/TCP
51.04 IP configuration Set the IP address
according your network
configuration.
51.05...08 IP address
51.09 Subnet CIDR
See the latest version of FENA-01/-
11/-21 Ethernet adapter module user's
manual (3AUA0000093568 [English])
in ABB library
www.abb.com/drives/documents
FENA-01/-11/-21
manual
For more information on ABB fieldbus
options and protocols, see the field-
bus communications web page
new.abb.com/drives/connectivity/field-
bus-connectivity
Fieldbus communications
3AXD50000551316 Rev A (EN) 2019-11-22
© Copyright 2019 ABB. All rights reserved.
Specifications subject to change without notice.
abb.com/drives