Ackuretta FreeShape 120 User manual

Quick Start Guide
2019/09
Documentation and Support
For the full set of FreeShape 120 documentation, go to:
https://ackuretta.com/support-center/freeshape120
For community feedback, see our Ackuretta’s User Group on Facebook:
https://www.facebook.com/groups/2164055477166718/
www.ackuretta.com
Setting Up Wi-Fi
You can easily operate your FreeShape 120 from your computer. You can upload prints
directly, and track print status. To set up your Wi-Fi connection:
1. Go to Network.
2. Select Wi-Fi.
3. Turn Wi-Fi Connection to “ON”.
4. Select your Wi-Fi network.
5. An IP address will appear. Key the IP address
into a browser on your computer.
Wi-Fi setup video:
https://youtu.be/6UzuHPnGYnI
Updating Firmware
Ackuretta is always adding new resins and improving functionality. If you are connected to
the Internet, check for the latest firmware:
1. Go to Settings.
2. Select Update.
3. Press Update firmware online.
Update firmware video:
https://youtu.be/C3ThWRO56vk
Print
You can print either over Wi-Fi or from your USB device.
1. Go to Print.
2. Choose USB or Computer, depending on your
location of your file.
3. Choose your IBF file.
4. Change your material setting, if necessary.
5. Press Print.
Print video:
https://youtu.be/3iRLnvvCwck

Package Contents
Ethernet Cable
Setup Guide
VatBuild Platform Print Screens (×2) Hex Key
Vat Film Sheets (×2)
Wi-Fi Dongle
FreeShape 120
Power Cable
Product Specifications
Machine Size 25 × 23 × 38 cm
Weight 9 kg
Print Size 120 × 68 × 140 mm
XY Resolution 47 μm
Slice Thickness 30 - 150 μm
Resin Wavelength 385~405 nm
Power Supply 110-240V AC, 50-60Hz
LCD
3D Print Technology
Software
Download and install the Alpha 3D software from
the Ackuretta website:
https://ackuretta.com/software/
For instructions on how to use Alpha 3D, see the
Alpha 3D Tutorials:
https://youtu.be/Ido7e5_QudE
Unboxing
1. Lift the printer out by the handles.
2. Take the hood off the printer and remove
the vat film. Put the film in a safe place.
3. Lift the printer by the base to pull it out of
its internal package.
4. Find the power cable in the CABLE box and
use it to plug the printer in.
Full unboxing video:
https://youtu.be/EzcqBJpHIKo
Side Boxes
There are four small boxes, in your printer package,
with the following contents:
PANEL: 2 Print Screens wrapped in protective packaging CABLE: 1 Ethernet cable and 1 Power Cable
TOOLS: 1 Hex Key (Allen wrench)
One box is empty.
Environment
Operate your FreeShape 120 in a temperature-
controlled room, between 18°-25° C (64°-77° F).
Ackuretta also recommends using UV-filtered LED
lights in your workspace for both printing and
cleaning.