Advaning SG Series User manual

C Series & SG Series Replace An Awning Arm
1. Use an adjustable wrench
to slightly loosen (but do
not remove) the locking
nut from the arm tip at
front bar connection.
2. Using a power drill and
3/16 metal drill bit,
carefully drill through the
existing rivet and shim at
the arm shoulder. Remove
the shim.
3. Remove the existing bolt
from the arm shoulder
with standard athead
screw driver and mallet
forcing the bolt to pop
out.
4. Now remove the loosened
nut from the arm tip.
Note: Save nut for
securing replacement arm.
1. Using a ladder, position yourself directly under the awning.
2. Secure the existing arm by wrapping it with the rope, tie downs, or bungee cords to prevent it from accidentally
springing open when removed. Leaving enough allowance for the awning to open approximately 5-7 inches.
3. Manually open the awning to 5-7 inches.
REMOVING THE EXISTING ARM
PREPARATION
What you will need:
A. Replacement Arm Kit; Includes: New
Replacement Arm, Bolt, Shim and Rivet
B. 6-8 ft. ladder
C. Rope, tie downs, or hook bungee cords
D. Drill and 3/16 metal bit
E. Riveter
F. Standard 3”-5” long at head screwdriver
G. Mallet
H. Adjustable wrench
I. Optional: Lubricant
1.A
2.B
3
1.B
2.C
4
2.A
2.D
Note: We recommend having an assistant to help support the awning arm during the replacement.
Electric Models: Please disconnect from power source before proceeding with arm replacement.
Your replacement arm will arrive securely tied together, DO NOT REMOVE the tie down until the arm is securely fastened to the awning.
Replacement Arm Kit

www.advaning.com Toll Free (US): [phone]
6.B
Our team prides itself on quality in product and service.
Should you have any concerns or questions, do not hesitate to reach us at [email protected].
1. Insert the new arm
shoulder into the existing
Easy Pitch mechanism.
2. Insert the new bolt
securing the arm shoulder
to Easy Pitch mechanism.
3. Combine the new shim
and the new rivet.
4. Insert shim and rivet into
riveter.
5. Using the riveter, install
the shim and rivet into the
arm shoulder.
6. Insert the arm tip to
front bar connection
and securely tighten the
locking nut on the arm tip.
7. Inspect the arm shoulder
and arm tip connection,
and remove the tie before
test operation.
5. Remove the existing arm.
Note: Ensure that the
existing arm is securely
tied before removing
to prevent the spring
mechanism from
activating.
INSTALLING THE NEW ARM
13
4 5.A 5.B
6.A 7
2
5.A 5.B
Note: DO NOT REMOVE the tie down on new arm until the arm is securely fastened to the awning.
Additional Notes:
• It is recommended to properly lubricate the new arm before operating. Lubricating instruction are
available at www.advaning.com/kcnder/upload/les/Lubricating_instruction.pdf.
• While replacing the arm, the pitch of the awning may move and will sometimes require adjustment.
• Electric Models: Please ensure that you test the new arm function and pitch manually 3-5 times
before connecting to power source.