Advantech PCM-3350 Series User manual

PCM-3350 Series
NS Geode 586-Level PC/104
CPU Module with SVGA/LCD/
LAN Interface
User's Manual

Copyright notice
This document is copyrighted, 2001. All rights are reserved.
The original manufacturer reserves the right to make
improvements to the products described in this manual at any time
without notice.
No part of this manual may be reproduced, copied, translated or
transmitted in any form or by any means without the prior written
permission of the original manufacturer. Information provided in this
manual is intended to be accurate and reliable. However, the original
manufacturer assumes no responsibility for its use, nor for any
infringements upon the rights of third parties which may result from its
use.
Acknowledgements
AMD is a trademark of Advanced Micro Devices, Inc.
Award is a trademark of Award Software International, Inc.
Cyrix is a trademark of Cyrix Corporation.
IBM, PC/AT, PS/2 and VGA are trademarks of International Business
Machines Corporation.
Intel and Pentium are trademarks of Intel Corporation.
Microsoft Windows®is a registered trademark of Microsoft Corp.
RTL is a trademark of Realtek Semiconductor Co., Ltd.
C&T is a trademark of Chips and Technologies, Inc.
UMC is a trademark of United Microelectronics Corporation.
Winbond is a trademark of Winbond Electronics Corp.
STPC is a trademark of SGS Thomson Corp.
For more information on this and other products, please
visit our website at: http://www.emacinc.com
This manual is for the PCM-3350F.
1st Edition Printed in Taiwan May 2001

Packing list
Before you begin installing your card, please make sure that the
following materials have been shipped:
• 1 PCM-3350 All-in-one single board computer
•CD-ROM or Disks for utility, drivers, and manuals (PDF format)
• 1 2.5" IDE flat cable, 44-pin to 44-pin
• 1 PS/2 keyboard & mouse cable
• 2serial port cables
• 1 parallel cable
• 1 26-34 pin FDD cable converter
• 1 floppy cable, for 3.5" FDD only
• 1 FDD flat cable
• 1 VGA cable
• 1 LAN cable

Contents
Chapter 1 General Information 1
1.1 Introduction....................................................................... 2
1.2 Features ............................................................................. 3
1.3 Specifications .................................................................... 4
1.3.1 Standard SBC functions .............................................. 4
1.3.2 VGA function .............................................................. 4
1.3.4 Ethernet function ........................................................ 5
1.3.5 Solid state disk ............................................................. 5
1.3.6 Mechanical and environmental ....................................5
1.4 Board dimensions ............................................................ 6
Chapter 2 Installation 7
2.1 Connectors ....................................................................... 8
2.2 Locating connectors ........................................................ 9
2.3 Safety precautions .......................................................... 10
2.4 Ethernet connector (CN1) (PCM-3350F/N only)...... 10
2.4.1 Ethernet connector (CN1) ......................................... 10
2.4.2 Network boot............................................................. 10
2.5 LCD display connector (CN2) ...................................... 10
2.6 Serial ports
(CN3: COM1; CN4: COM2/RS-232;
CN18: COM2/RS-422/485) ......................................... 11
2.6.1 RS-232 connection (COM1: CN3) ............................ 11
2.6.2 RS-232/422/485 connection
(COM2: CN4: RS-232; CN18: RS-422/485) ..................... 11
2.7 EIDE HDD connector (CN5) ....................................... 12
2.7.1 Connecting the hard drive ......................................... 12
2.8 PC/104 connector (CN6) ............................................... 12
2.9 Parallel port connector (CN7) ...................................... 13
2.10 Backlight connector (CN8)........................................... 13

2.11 VGA connector (CN9) ................................................... 13
2.11.1 CRT display connector (CN9) ................................. 13
2.12 Main power (+5 V / +12 V) connector (CN11) .......... 13
2.13 PS/2 keyboard/mouse connector (CN12) ................... 14
2.14 FDD connector (CN14) ................................................. 14
2.14.1 Connecting the floppy drive ..................................... 14
2.15 CompactFlash™ socket (CN16) .................................. 15
2.16 USB connector (CN17) ................................................. 15
2.17Multifunction Jumpers (MJ1)......................................16
2.17.1 Auxilary power connector (MJ1-A)........................16
2.17.2 Fan connector (MJ1-B) ........................................... 17
2.17.3 Reset button connector (MJ1-C) ............................. 17
2.17.4 IR connector (MJ1-D) ............................................ 17
2.17.5 Watchdog timer configuration (MJ1-E) ................... 17
2.18 SO DIMM socket (Slot1) ............................................. 18
2.18.1 Installing SODIMMs ............................................... 18
Chapter 3 Software Configuration 21
3.1 Introduction..................................................................... 22
3.2 Utility CD disk ................................................................ 22
3.3 VGA display software configuration ............................ 22
3.4 Connections for two standard LCDs ........................... 24
3.4.1 Connections for Toshiba LTM10C042(640 x 480 TFT
color LCD) ......................................................................... 24
3.4.2 Connections for Toshiba LTM12C275A
(800 x 600 TFT color LCD) .............................................. 25
Chapter 4 Award BIOS Setup 27
4.1 System test and initialization ........................................ 28
4.1.1 System configuration verification .............................. 28
4.2 Award BIOS setup ......................................................... 29
4.2.1 Entering setup ............................................................ 29
4.2.2 Standard CMOS setup .............................................. 30
4.2.3 BIOS features setup .................................................. 31
4.2.4 Chipset features setup ............................................... 32

4.2.5 Power management setup ......................................... 33
4.2.6 PnP/PCI configuration .............................................. 34
4.2.7 Integrated peripherals ................................................ 35
4.2.8 Change password ...................................................... 36
4.2.9 Save & exit setup ...................................................... 37
4.2.10 Exit without saving .................................................. 37
Chapter 5 PCI Bus Ethernet Interface 39
5.1 Introduction..................................................................... 40
5.2 Installation of Ethernet driver ..................................... 40
5.2.2 Installation for Windows 98/2000 .............................. 41
5.3 Further information ........................................................ 44
Chapter 6 SVGA Setup 45
6.1 Introduction..................................................................... 46
6.1.1 Chipset ....................................................................... 46
6.1.2 Display memory ........................................................ 46
6.2 Installation of SVGA driver .......................................... 46
6.2.1 Installation for Cyrix MediaGX Certified drivers for
Windows 95/98. Insert the disk into the CD-ROM drive. .. 47
6.2.2 Installation for Windows NT ..................................... 50
6.3 Further information ........................................................ 56
Appendix A Programming the Watchdog Timer 57
A.1 Programming the watchdog timer ............................... 58
Appendix B Installing PC/104 Modules 61
B.1 Installing PC/104 modules ............................................ 62
Appendix C Pin Assignments 65
C.1 Ethernet connector (CN1) ............................................ 66
C.2 LCD connector (CN2) ................................................... 67
C.3 COM1 connector (CN3) ............................................... 68
C.4 COM2 connector (CN4) ............................................... 68
C.5 EIDE hard drive connector (CN5) .............................. 69

C.6 PC/104 connector (CN6) ............................................... 70
C.7 Parallel port connector (CN7) ...................................... 70
C.8 Backlight connector (CN8)........................................... 71
C.9 VGA connector (CN9) ................................................... 71
C.10 Main power (+5 V) connector (CN11) ........................ 72
C.11 PS/2 keyboard/mouse connector (CN12) ................. 72
C.12 FDD connector (CN14) ................................................. 73
C.13 CompactFlash™ socket (CN16) .................................. 74
C.14 COM2 connector for 422/485 (CN18) ........................ 76
C.15 Multifunction Jumpter (MJ1) ...................................... 76
Appendix D System Assignments 79
D.1 System I/O ports ............................................................ 80
D.2 DMA channel assignments........................................... 81
D.3 Interrupt assignments ................................................... 82
D.4 1st MB memory map ..................................................... 83

Figures
Figure 1-1: PCM-3350 dimensions ................................................................ 6
Figure 2-1: Locating connectors (component side) ..................................... 9
Figure 2-2: Locating connectors (solder side) ............................................. 9
Figure 3-1: Contents of the PCM-3350 Series utility disk ............................. 22
Figure 3-2: BIOS VGA setup screen .............................................................. 23
Figure 4-1: BIOS setup program initial screen ............................................. 29
Figure 4-2: CMOS setup screen ................................................................... 30
Figure 4-3: BIOS features setup ................................................................... 31
Figure 4-4: Chipset features setup ............................................................... 32
Figure 4-5: Power management setup ......................................................... 33
Figure 4-6: PnP/PCI configuration ................................................................ 34
Figure 4-7: Integrated peripherals ................................................................ 35
Figure B-1: PC/104 module mounting diagram ........................................... 63
Figure B-2: PC/104 module dimensions (mm) (±0.1) ................................. 63
Figure C-1: CompactFlash™ socket ............................................................ 75

Tables
Table 2-1: Connectors ...................................................................................................... 8
Table 2-2: Serial port connections (COM1, COM2) ........................................................ 11
Table 2-3: Serial port default settings ............................................................................ 12
Table B-1: PCM-3350 PC/104 connectors (CN6) ........................................................... 64
Table C-1: Ethernet connector (CN1) ............................................................................. 66
Table C-2: LCD connector (CN2) .................................................................................... 67
Table C-3: COM1 connector (CN3) ................................................................................ 68
Table C-4: COM2 connector (CN4) ................................................................................ 68
Table C-5: EIDE hard drive connector (CN5) ................................................................. 69
Table C-7: Parallel port connector (CN7) ....................................................................... 70
Table C-9: VGA connector (CN11) ................................................................................ 71
Table C-8: Backlight connector (CN8) ............................................................................ 71
Table C-10: Main power (+5 V) connector (CN11) ........................................................ 72
Table C-11: PS/2 keyboard/mouse connector (CN12) ................................................... 72
Table C-12: FDD connector (CN14) ............................................................................... 73
Table C-13: CompactFlash™ socket (CN16) ................................................................. 74
Table C-14: COM2 connector for 422/485 (CN18) ........................................................ 76
Table C-15: MJ1-A, -5 V, -12 V input ............................................................................. 76
Table C-16: MJ1-B, fan connector ................................................................................. 76
Table C-18: MJ1-D, IR connector .................................................................................... 77
Table C-19: MJ1-E, watchdog jumper ............................................................................ 77
Table C-17: MJ1-C, reset button ..................................................................................... 77
Table D-1: System I/O ports ........................................................................................... 80
Table D-2: DMA channel assignments ........................................................................... 81
Table D-3: Interrupt assignments ................................................................................... 82
Table D-4: 1st MB memory map ...................................................................................... 83