
in order to avoid a hazard.
* Switch off the appliance and disconnect from supply before changing accessories or approaching parts that move in
use.
* Care shall be taken when handling the sharp cutting blades, emptying the bowl and during cleaning.
* Using the machine, do not operate the blender without dip into the food. Do not operate the machine over 20 seconds
when the blender is unloaded.Avoid damage the motor from overheat.
* If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.
* Always disconnect the blender from the supply if it is left unattended and before assembling, disassembling or
cleaning.
* Do not allow children to use the blender without supervision.
SWITCH KEY
The switchA button key is for low speed, the switch B button key is for Turbo speed.
* Press any switch key, the machine will work. Loosen the switch key, the machine will stop.
USING THE BLENDING
* The blender is used for mince or mix the food.
* Move the hot pan away from fire and wait until its temperature drop down to be below 70C. To avoid the housing
overheated.
* Set the blender on the housing, screw tightly and lock it.
* Connect to power. To avoid spattering, put the blender into ingredients before switching on the power.
* Hold the mixing cup tightly and push down the switch key. The liquid ingredients you are mixing cannot submerge
the juncture of the blender.
* Move the blender downwardly and upwardly.
* After use, please pull out the plug and disassembly the fitting.
* Put 200g Carrot or similar food into 300 ml water. Run the machine no more than 60 seconds and rest the machine 1
minute for further operation.
* Always disconnect the blender from the supply if it is left unattended and before assembling, disassembling or
cleaning.
* Do not allow children to use the blender without supervision.
RECIPES TIPS:
*** Ingredients:
Egg 60g; Baking powder 10g; Salt 10g; Sugar 5g; Water 100g; Oil 25g, Flour 250g;
*** Operation:
1. All Ingredients into container
2. Cover and lock the lid into container
3. Lock the body unit into chopper unit
4. Start the machine. Not allowed to continuously use more than 15 seconds, should cool down at least 2 minutes. The
motion could not be more than 3 cycles.
CLEANING METHOD