AirSep newlife intensity User manual

Hook-Up Instructions
For Oxygen Concentrator to Hyperbaric Chamber
Parts:
•“Christmas Tree” Connector
•Connector
•Connecting tubing w/Valve Nut
Step 1. Screw on the threaded end of the “Christmas Tree” connector to
the oxygen port on the Oxygen concentrator. Make finger tight.
Step 2. Push the longer end of the connecting hose on to the “Christmas
Tree” to secure.
Step 3. Remove the Brass nut from the “Head” of the Hyperbaric
Chamber. Nut is identified by a green circle around it.
Step 4. Remove the end from the shorter end of the connecting hose,
insert through the opening where the nut was removed and thread the
nut on the tubing. Tighten snugly with a wrench.
Step 5. Reach inside the chamber and pull the connecting hose through
to seat the black tape in the back side of the valve nut.
Step 6. Replace the end on to the tubing with the larger end facing out.
Twist on gently to insure there is no kinking in the tubing. The plastic
connector fits in this end and may be used to connect mask or cannula
for in chamber use.
You are now ready to use the Concentrator with the chamber.

Trouble Shooting your Concentrator
For your concentrator to operate effectively the
following steps need to be followed:
For maximum effectiveness of your Airsep Newlife Intensity:
The volume setting should be at 8 on the scale.
Do not place the setting at 10 or beyond.
•Should the Yellow light come in during the treatment, the first thing
to check is that all the tubing lines are clean and not pinched or
bent. Any lines bent will result in a diminished flow of Oxygen and
cause the light to come on.
•To verify that this is the problem, disconnect the tubing at the
concentrator and turn the unit “ON”. If the concentrator ramps up
normally then the issue is one of the tubing lines either inside the
chamber with the mask tubing or on the outside of the chamber
with the concentrator tubing. Ensure that all tubing is straight for
the oxygen to flow properly.
•Next check the filter at the top of the Concentrator to ensure that
it is clean and free flowing. If it is not clean, this is the source of
the yellow light coming on and the diminished flow of Oxygen.
Take filter out, clean thoroughly and replace.
•If the concentrator yellow light is still “Yellow”, Push the black
“RESET” button on the front of the concentrator and turn “ON”
If all of the above efforts fail:
Call American Discount Medical at 800 877 9100—Office Hours
are 8-5 CST, Monday through Friday.

For maximum effectiveness of
your Airsep Newlife Intensity:
The volume setting should be at
8 on the scale
Never place the setting at
10 or beyond.
#2
Always turn “ON” your oxygen
concentrator BEFORE turning “ON” your
hyperbaric Chamber.
Turn “OFF” the hyperbaric chamber
before turning “OFF” the oxygen
concentrator.
In short—Turn “ON” your concentrator
first and turn it “OFF” last.
IMPORTANT NOTES
#1

This procedure will ensure that the
chamber back pressure does not damage
the concentrator.