Trouble Shooting
Problem Possible Reason How to Solve
No Sound:
Europe:
AKG Acoustics GmbH
Laxenburger Strasse 254
A1230 Vienna - AUSTRIA
Tel.: +43-1-86654-0
USA:
AKG Acoustics, U.S.
8500 Balboa Blvd. Dock 15
Northridge, CA 91329, USA
Tel.: +1-818-920-3224
6a. Check cable and replace if necessary.
7. Ensure that the microphone element
is on the side facing the presenters
mouth. The element has a larger
mesh surface than the rear side port.
Distortion:
Also read the transmitter and receiver manuals!
Risk of damage
Please make sure that the piece of equipment your microphone
will be connected to fulfills the safety regulations of force in your country.
1. Power to mixer and/or
amplifier is off.
2. Channel or master fader
on mixer, or volume
control on amplifier is at
zero.
3. Microphone is not connected
to mixer or amplifier.
4. Cable connectors are
seated loosely.
5. Cable is defective.
6. No supply voltage.
7. Microphone capsule is facing away
from the presenter.
1. Switch power to mixer or amplifier on.
2. Set channel or master fader on mixer
or volume control on amplifier
to desired level.
3. Connect microphone to
mixer or amplifier.
4. Check cable connectors for
secure seat.
5. Check cable and replace if damaged.
6. Switch phantom power on.
1. Gain controlon the mixer set too high.
2. Mixer input in overload.
1. Turn gain control down CCW.
2. Connect a 10-dB preattenuation pad
between microphone and mixer.
1. When scrapping the equipment, separate the case, circuit boards and cables and dispose all
components in accordance with local waste disposal rules.
2. The packaging of the equipment is recyclable. Dispose packaging in an appropriate container.
provided by the local waste collection/ recycling entity and observe all local legislation relating
to waste disposal environment and recycling.
