Allseating ENTAIL Installation instructions

Disassembly Instructions
ENTAIL
Document No:
Issue Date:
Revision:
Revised Date:
CDM-90
1-Oct 2020
0
1
This disassembly instruction is applicable to ENTAIL Task Chair.
Backrest
(Plastic, Mesh)
Mechanism
(Metal)
Cylinder
(Metal)
Caster
(Plastic with Metal)
Base
(Plastic)
Seat
(Foam, Wood)
For material recycling information please refer to the End of Life Recovery Matrix
and List of Recycling Facilities, which is available at www.allseating.com.

Disassembly Instructions
ENTAIL
Document No:
Issue Date:
Revision:
Revised Date:
CDM-90
1-Oct 2020
0
2
Tools:
#2 #3 Phillips head, Rubber mallet or hammer, Small flathead screwdriver, Allen
key, Box cutter.
Skill Set:
Good manual dexterity
Estimated Time:
7 minutes per chair
Steps:
1. Base - 1min
Hold the base legs firmly and strike the bottom of cylinder with a hammer
until base comes loose, remove base.
2. Casters - 2min
Grasp and pull to remove casters from the base.
3. Cylinder - 1min
Remove cylinder by placing one hand on can of cylinder and hit the bottom of
the mechanism with hammer until cylinder separates from mechanism.
4. Mechanism - 3min
Turn the chair upside down, so the bottom is visible. Locate the five (5)
fasteners located underneath. Remove the mechanism from the seat.
For further dismantling, the plastic and arm cap foam from the arms and the plastic from the casters can
still be removed. Steel will be left. The plastic and foam could be disposed of and the recovered metal
could be recycled.