Allseating FOSTER Bench, Ottoman and Table Installation instructions

Table Top
(Wood)
Frame
(Steel )
For material recycling information please refer to the Allseating End of Life Recovery
and List of Recycling Facilities, which is available at www.allseating.com
Disassembly Instructions
FOSTER Bench, Ottoman and Table
Document: CAM-320
Revision: 01
Date: May 17, 2013
Glides
(Plastic)
Pad/Cushion
(Upholstered/Foam/Wood)

Disassembly Instructions
FOSTER Bench, Ottoman and Table
Document: CAM-320
Revision: 01
Date: May 17, 2013
Tools: #2 #3 Phillips Head, Rubber Mallet or Hammer, Plier
Skill Set: Good manual dexterity.
Estimated Time: 12min per chair.
Steps:
1. Nylon Hole Plug - 3min
Turn the bench/ottoman upside down so the bottom is visible. Locate 8 nylon hole plug located
underside of the frame. With pliers, firmly grasp the nylon plug and wiggle upward until free.
Repeat process for all 8 plugs.
2. Table Top - 2min
Turn the chair upside down so the bottom is visible. Locate 2 fastener located underside of the
frame and unfasten. Pull table-top upward to remove from the frame.
3. Pad/Cushion - 5min
Turn the chair upside down, so the bottom is visible. Locate 6 fasteners located underside of the
frame and unfasten. Remove the pad/cushion from the frame. Flip the bench/ottoman to the
opposing side and repeat the process.
4. Feet Glides - 2min
Once both the table top and cushions are removed from the frame, turn the chair upside down to
access glides. With pliers, firmly grasp the glide and wiggle upward until free. Repeat process for
all four feet.