Allseating MULTITEK Installation instructions

Back
(Plastic)
Arm
(Plastic/Steel )
Seat
(Plastic or
Plastic/Plywood/Foam)
Mechanism
(Steel )
Cylinder
(Steel )
Base
(Plastic)
Caster
(Plastic)
For material recycling information please refer to the End of Life Recovery Matrix
and List of Recycling Facilities, which is available at www.allseating.com.
Disassembly Instructions
MULTITEK
Document: CAM-310
Revision: 01
Date: June 7, 2012

Disassembly Instructions
MULTITEK
Document: CAM-310
Revision: 01
Date: June 7, 2012
Tools: #2 #3 Phillips Head, Rubber Mallet or Hammer, Allen Key.
Skill Set: Good manual dexterity.
Estimated Time: 15min per chair.
Steps:
1. Armrest - 2min
Turn the chair upside down, so the bottom is visible. Locate the four fasteners locate on the
underside of the seat pan and unfasten. Remove the arm rest from the seat frame.
2. Arm Cap - 1min
Turn the arm upside down so the bottom is visible. Locate the two fasteners and unfasten.
Remove the arm cap from the arm.
3. Back Rest - 4min
Pull the back upward to remove back rest from the chair frame or use rubber mallet, knock the
underside of the back rest. Continue to knock until the back rest is free from the frame.
4. Casters - 2min
Lay chair on back. Grasp and pull to remove casters from the base.
5. Base - 1min
Hold the base legs firmly and strike the bottom of cylinder with a hammer until base comes
loose, remove base.
6. Cylinder - 1min
Remove cylinder by placing one hand on can of cylinder and hit the bottom of the mechanism
with hammer until cylinder separates from mechanism.
7. Mechanism - 2min
Turn the chair upside down so the bottom is visible. Locate the four fasteners located on the
underside of the seat frame and unfasten. Remove the mechanism from the seat frame.
8. Seat - 2min
Turn the chair upside down so the bottom is visible. Locate the two fasteners located on the
underside of the seat frame and unfasten. Remove seat from the seat frame. In case of
upholstered seat, locate the four fasteners on the underside of the seat and unfasten. Remove
the upholstered seat from the polypropylene seat.