Allseating HALSA Single Midback Installation instructions

For material recycling information, please refer to the End of Life Recovery Matrix and
Listing Recycling Facilities, which is available at www.allseating.com.
Document: CAM-326
Revision: 01
Date: May 19, 2016
Disassembly Instructions
HALSA Single Midback
Back Frame
(Steel )
Seat
(Upholstered/Foam)
Arm
(Steel )
Back
(Upholstered/Foam)
Arm Pad
(Plastic or Wood)
Chair Frame
(Steel )
Glides
(Plastic)

Disassembly Instructions
HALSA Single Midback
Document: CAM-326
Revision: 01
Date: May 19, 2016
Tools: #2 #3 Phillips Head, Pliers, Allen Key, 5/16"-18 Head
Skill Set: Good manual dexterity
Estimated Time: 10 min. per chair
Steps:
1. Back Rest - 2 min.
Locate the 2 fasteners at the rear of the chair frame, and unfasten them. Pull the backrest
upwards to remove it from the frame.
In the case of a double chair, repeat step 1 again for the adjacent backrest.
2. Seat - 4 min.
Turn the chair upside down so the bottom is easily accessible. Locate the fasteners on the
underside of the frame, and unfasten them to remove the seat from the chair frame.
In the case of a double chair, repeat step 2 again for the adjacent seat.
3. Arm Pad - 2 min.
Locate the 2 fasteners on the underside of the armrest, and unfasten them to remove the
arm pads.
4. Glides - 2 min.
Turn the chair upside down. Using pliers, firmly grasp the feet glides, and wiggle/pull
upwards until free from the legs. Repeat the process for all four chair legs.