Allseating INERTIA Installation instructions

Back Frame
(Steel )
Back
(Mesh or Upholstered) Arm
(Plastic/Steel )
Seat
(Foam/Plywood)
Mechanism
(Steel )
Foot Rest
(Steel )
Cylinder
(Steel )
Base
(Plastic)
Caster
(Plastic)
For material recycling information please refer to the End of Life Recovery Matrix
and List of Recycling Facilities, which is available at www.allseating.com.
Disassembly Instructions
INERTIA
Document: CAM-308
Revision: 01
Date: June 7, 2012

Disassembly Instructions
INERTIA
Document: CAM-308
Revision: 01
Date: June 7, 2012
Tools: #2 #3 Phillips Head, Rubber Mallet or Hammer, Allen Key, Box Cutter
Skill Set: Good manual dexterity.
Estimated Time: 16min per chair.
Steps:
1. Armrest - 2min
Turn the chair upside down, so the bottom is visible. Locate the four fasteners locate on the
underside of the seat pan and unfasten. If the chair is with width adjustable option, loose the
arm knob located underside of the seat panel and remove the arm rest. Remove the width
adjustable bracket by unfastening four screws located underside of the seat pan. Flip the chair
to the opposing side and repeat the process.
2. Arm Cap - 1min
Turn the arm upside down so the bottom is visible. Locate the two fasteners and unfasten.
Remove the arm cap from the arm.
3. Back Bar - 1min
Locate the three fasteners located on the underside of seat pan and unfasten. Remove the
backrest and back bar from the chair.
4. Back Rest - 2min
Mesh Back: Carefully cut through the mesh with the help of box cutter. Pull the mesh upward
to remove from the chair frame.
Upholstered Back: Carefully cut through the upholstery with the help of box cutter. Pull the
upholstery upward to remove from the chair frame
5. Casters - 2min
Lay chair on back. Grasp and pull to remove casters from the base.
6. Base - 1min
Hold the base legs firmly and strike the bottom of cylinder with a hammer until base comes
loose, remove base.
7. Cylinder - 1min
Remove cylinder by placing one hand on can of cylinder and hit the bottom of the mechanism
with hammer until cylinder separates from mechanism.

Disassembly Instructions
INERTIA
Document: CAM-308
Revision: 01
Date: June 7, 2012
8. Foot Rest - 1min
Remove footrest by placing one hand on cylinder and the other on footrest. Rotate the footrest
in a direction to loose. Read the instruction on footrest for direction.
9. Mechanism - 2min
Turn the chair upside down so the bottom is visible. Locate the four fasteners located on the
underside of the seat pan or seat slider and unfasten. Remove mechanism from the seat pan
or seat slider.
10. Seat - 2min
Turn the chair upside down so the bottom is visible. Locate the four fasteners located on the
underside of the mechanism or seat slider and unfasten. Remove seat from mechanism or
seat slider.
11. Seat Slider - 1min
Turn the chair upside down so the bottom is visible. Locate the four fasteners located on the
underside of the seat pan and unfasten. Remove seat slider from seat pan.