Allseating RAY Installation instructions

Head Rest
(Foam/Plastic)
Back
(Foam/Plastic)
Arm
(Aluminium/Plastic)
Seat
(Foam/Plywood/Plastic)
Mechanism
(Steel ) Cylinder
(Steel )
Base
(Aluminium)
Caster
(Plastic)
For material recycling information please refer to the End of Life Recovery Matrix
and List of Recycling Facilities, which is available at www.allseating.com.
Disassembly Instructions
RAY
Document: CAM-312
Revision: 01
Date: June 7, 2012

Disassembly Instructions
RAY
Document: CAM-312
Revision: 01
Date: June 7, 2012
Tools: #2 #3 Phillips Head, Rubber Mallet or Hammer, Allen Key, Box Cutter
Skill Set: Good manual dexterity.
Estimated Time: 15min per chair.
Steps:
1. Mechanism - 2min
Turn the chair upside down, so the bottom is visible. Locate the four fasteners located on the
underside of the seat pan and unfasten. Remove mechanism from the seat pan.
2. Seat Panel - 2min
Turn the chair upside down, so the bottom is visible. Locate the eight fasteners and unfasten.
Remove the seat panel from the seat .
3. Back Rest - 4min
In RAY chairs, the fasteners may be concealed between the back rest and back panel. In this
event, carefully insert the tip of screwdriver in between the back panel and back rest. Push
down on the handle of the screwdriver while also applying pressure into the back panel and
back rest to pry both apart. Continue to apply pressure in this way until the back panel is free
from the back rest. Once the fasteners are sufficiently exposed, remove the back rest by
unscrewing fasteners.
4. Back Bar - 1min
Locate the four fasteners located on the underside of seat pan and unfasten. Remove the
backrest and back bar from the chair.
5. Armrest - 2min
Turn the chair upside down, so the bottom is visible. Locate the four fasteners locate on the
underside of the seat pan and unfasten. Flip the chair to the opposing side and repeat the
process.
6. Casters - 2min
Lay chair on back. Grasp and pull to remove casters from the base.
7. Base - 1min
Hold the base legs firmly and strike the bottom of cylinder with a hammer until base comes
loose, remove base.
8. Cylinder - 1min