Allseating CPOD Installation instructions

Back
(Plastic/Mesh)
Arm
(Plastic/Steel )
Seat
(Foam/Plywood)
Mechanism
(Steel ) Cylinder
(Steel )
Base
(Plastic or Aluminum)
Caster
(Plastic)
For material recycling information please refer to the Allseating End of Life Recovery
and List of Recycling Facilities, which is available at www.allseating.com
Disassembly Instructions
CPOD
Document: CAM-303
Revision: 01
Date: June 7, 2012

Disassembly Instructions
CPOD
Document: CAM-303
Revision: 01
Date: June 7, 2012
Tools: #2 #3 Phillips Head, Rubber Mallet or Hammer, Allen Key
Skill Set: Good manual dexterity.
Estimated Time: 15min per chair.
Steps:
1. Armrest - 2min
Turn the chair upside down, so the bottom is visible. Locate the four fasteners locate on the
underside of the seat pan and unfasten. If the chair is with width adjustable option, loose the
arm knob located underside of the seat panel and remove the arm. Remove the width
adjustable bracket by unfastening screws located underside of the seat pan. Flip the chair to
the opposing side and repeat the process.
2. Arm Cap - 1min
Turn the arm upside down so the bottom is visible. Locate the two fasteners and unfasten.
Remove the arm cap from the arm.
3. Back Bar - 1min
Locate the three fasteners located on the underside of mechanism and unfasten. Remove the
backrest and back bar from the chair.
4. Back Rest - 2min
Separate the back rest from the back frame by unfastening 3 screws located on the back
frame. Fasteners are covered by the plastic caps; remove the plastic caps with the help of
flathead screw driver. Locate the fasteners and unfasten.
5. Casters - 2min
Lay chair on back. Grasp and pull to remove casters from the base.
6. Base - 1min
Hold the base legs firmly and strike the bottom of cylinder with a hammer until base comes
loose, remove base.

Disassembly Instructions
CPOD
Document: CAM-303
Revision: 01
Date: June 7, 2012
7. Cylinder - 1min
Remove cylinder by placing one hand on can of cylinder and hit the bottom of the mechanism
with hammer until cylinder separates from mechanism.
8. Mechanism - 2min
Turn the chair upside down so the bottom is visible. Locate the four fasteners located on the
underside of the seat pan or seat slider and unfasten. Remove mechanism from the seat
pan or seat slider.
9. Seat - 2min
Turn the chair upside down so the bottom is visible. Locate the four fasteners located on the
underside of the seat slider or seat pan and unfasten. Remove seat from the mechanism or
seat slider.
10. Seat Slider - 1min
Turn the chair upside down so the bottom is visible. Locate the four fasteners located on the
underside of the seat pan and unfasten. Remove seat slider from seat pan.