Allseating DAX Conference Installation instructions

Back
(Plastic/Plywood)
Arm
(Plastic)
Seat
(Foam/Plywood)
Mechanism
(Steel ) Cylinder
(Steel )
Base
(Plastic or Aluminium)
Caster
(Plastic)
For material recycling information please refer to the End of Life Recovery Matrix
and List of Recycling Facilities, which is available at www.allseating.com.
Disassembly Instructions
DAX Conference
Document: CAM-304
Revision: 01
Date: June 7, 2012

Disassembly Instructions
DAX Conference
Document: CAM-304
Revision: 01
Date: June 7, 2012
Tools: #2 #3 Phillips Head, Rubber Mallet or Hammer, Allen Key, Box Cutter
Skill Set: Good manual dexterity.
Estimated Time: 12min per chair.
Steps:
1. Armrest - 2min
Locate two fasteners on armrest by removing plastic screw covers and unfasten. Remove
armrest from the chair. Flip the chair to the opposing side and repeat the process.
2. Back Bar/Back Rest - 2min
Locate the three fasteners located on the underside of seat pan and unfasten. Remove the
backrest and back bar from the chair.
3. Casters - 2min
Lay chair on back. Grasp and pull to remove casters from the base.
4. Base - 1min
Hold the base legs firmly and strike the bottom of cylinder with a hammer until base comes
loose, remove base.
5. Cylinder - 1min
Remove cylinder by placing one hand on can of cylinder and hit the bottom of the mechanism
with hammer until cylinder separates from mechanism.
6. Mechanism - 2min
Turn the chair upside down, so the bottom is visible. Locate the four fasteners located on the
underside of the seat pan and unfasten. Remove mechanism from the seat pan.
7. Seat - 2min
Turn the chair upside down, so the bottom is visible. Locate the four fasteners located on the
underside of the mechanism and unfasten. Remove seat from mechanism.