Allseating DOVE Installation instructions

These disassembly instructions are also application to DOVE Scooter Stool.
Back
(Plastic)
Back Bar
(Steel ) Seat
(Plastic)
Mechanism
(Steel ) Cylinder
(Steel )
Base
(Plastic)
Caster
(Plastic
For material recycling information please refer to the End of Life Recovery Matrix
and List of Recycling Facilities, which is available at www.allseating.com.
Disassembly Instructions
DOVE
Document: CAM-305
Revision: 01
Date: June 7, 2012

Disassembly Instructions
DOVE
Document: CAM-305
Revision: 01
Date: June 7, 2012
These disassembly instructions are also application to DOVE Scooter Stool.
Tools: #2 #3 Phillips head, Rubber mallat or hammer.
Skill Set: Good manual dexterity.
Estimated Time: 12min per chair.
Steps:
1. Back Rest - 2min
In Dove chair, fasteners are exposed at the rear of the back rest. Locate the two fasteners and
unfasten. Remove the back rest.
2. Back Bar - 1min
Once the back rest is removed, locate 3 fasteners located underside of the mechanism and
unfasten. Remove back bar from the mechanism.
3. Casters - 2min
Lay chair on back. Grasp and pull to remove casters from the base.
4. Base - 2min
Hold the base legs firmly and strike the bottom of cylinder with a hammer until base comes
loose, remove base.
5. Cylinder - 1min
Remove cylinder by placing one hand on can of cylinder and hit the bottom of the mechanism
with hammer until cylinder separates from mechanism.
6. Mechanism - 2min
Turn the chair upside down so the bottom is visible. Locate the four fasteners located on the
underside of the seat pan or seat slider and unfasten. Remove mechanism from the seat pan
or seat slider.
7. Seat - 2min
Turn the chair upside down so the bottom is visible. Locate the four fasteners located on the
underside of the seat pan and unfasten. Remove seat from the mechanism.