Allseating L1 Installation instructions

Disassembly Instructions
L1 Task Chair
Document No:
Issue Date:
Revision:
Revised Date:
CDM-L1024
19-MAY-2020
0
1
This disassembly instruction is applicable to L1 task chair.
Backrest
(plastic)
Base
(plastic)
Mechanism
(Steel)
Arms
(plastic)
For material recycling information please refer to the End of Life Recovery Matrix
and List of Recycling Facilities, which is available at www.allseating.com.
Seat and Shroud
(plastic + foam)
Headrest
(plastic + foam)
Cylinder
(Steel)
Casters x5 (Plastic
and Steel)

Disassembly Instructions
L1 Task Chair
Document No:
Issue Date:
Revision:
Revised Date:
CDM-L1024
19-MAY-2020
0
2
Tools: Philips Screwdriver, #6 Allen Key Wrench, Hammer, Rubber Mallet
Skill Set: Good manual dexterity
Estimated Time: 5 min. per chair
Steps: 1. Base –2 min.
Turn the chair upside down and start hitting the bottom of the cylinder with a
hammer or a mallet while pulling the base upwards.
2. Cylinder –1 min.
Hold the cylinder and pull it upwards while hitting the surrounding area of the
mechanism near where the cylinder is attached with a hammer or a mallet to loosen
the cylinder.
3. Back –1 min.
Use a #6 Allen key wrench to remove the three (3) screws off the back to separate the
back from the mechanism.
4. Mechanism –1 min.
Use a Philips screwdriver to remove the four (4) screws off the mechanism to
separate the mechanism from the seat.
Optional: The cylinder can be left attached on the mechanism if both cylinder and mechanism
are for disposal.
The casters may further be removed from the base and the steel pins pulled off from
each caster for recycling.