Allseating AYLES 41016-LB-FA-F-ODRIFT-AS-F-ODRIFT Installation instructions

Disassembly Instructions
AYLES CHAIR
Document No:
Issue Date:
Revision:
Revised Date:
CDM-41016
21-Jun-17
0
1
This disassembly instruction is applicable to AYLES Chair.
Chair Frame
(Foam, Wood, Metal)
Mechanism
(Metal)
Cylinder
(Metal)
Caster
(Plastic with Metal)
Base
(Metal)
Seat
(Foam, Wood)
For material recycling information please refer to the End of Life Recovery Matrix
and List of Recycling Facilities, which is available at www.allseating.com.

Disassembly Instructions
AYLES CHAIR
Document No:
Issue Date:
Revision:
Revised Date:
CDM-41016
21-Jun-17
0
2
Tools:
#2 #3 Phillips head, Rubber mallet or hammer, Small flathead screwdriver, Allen
key, Box cutter.
Skill Set:
Good manual dexterity
Estimated Time:
7 minutes per chair
Steps:
1. Base - 1min
Hold the base legs firmly and strike the bottom of cylinder with a hammer
until base comes loose, remove base.
2. Casters - 2min
Grasp and pull to remove casters from the base.
3. Cylinder - 1min
Remove cylinder by placing one hand on can of cylinder and hit the bottom of
the mechanism with hammer until cylinder separates from mechanism.
4. Mechanism - 3min
Turn the chair upside down, so the bottom is visible. Locate the five (5)
fasteners located underneath. Remove the mechanism from the seat.
For further dismantling, the upholstery from the Chair Frame could be removed. The foam and metal
would be left. The foam could be disposed of and the recovered metal could be recycled.

Disassembly Instructions
AYLES OTTOMAN
Document No:
Issue Date:
Revision:
Revised Date:
CDM-41X51
20-Jun-17
0
1
This disassembly instruction is applicable to AYLES Ottoman.
Mechanism
(Metal)
Cylinder
(Metal)
Base
(Metal)
Seat
(Foam, Wood)
For material recycling information please refer to the End of Life Recovery Matrix
and List of Recycling Facilities, which is available at www.allseating.com.

Disassembly Instructions
AYLES OTTOMAN
Document No:
Issue Date:
Revision:
Revised Date:
CDM-41X51
20-Jun-17
0
2
Tools:
#2 #3 Phillips head, Rubber mallet or hammer, Small flathead screwdriver, Allen
key, Box cutter.
Skill Set:
Good manual dexterity
Estimated Time:
5 minutes per chair
Steps:
1. Base - 1min
Hold the base legs firmly and strike the bottom of cylinder with a hammer until
base comes loose, remove base.
2. Cylinder - 1min
Remove cylinder by placing one hand on can of cylinder and hit the bottom of
the mechanism with hammer until cylinder separates from mechanism.
3. Mechanism - 3min
Turn the chair upside down, so the bottom is visible. Locate the four (4)
fasteners located underneath. Remove the mechanism from the seat.