Allseating VIVA Installation instructions

Back Frame
(Plastic/Aluminum)
Back
(Mesh)
Arm
(Plastic/Steel )
Seat
Mechanism
(Steel )
Cylinder
(Foam/Plywood/Plastic)
(Steel )
Base
(Plastic)
Caster
(Plastic)
For material recycling information please refer to the Allseating End of Life Recovery
Options Matrix and Allseating Matrix of Recycling Infrastructure, which is available at
www.allseating.com.
Disassembly Instructions
VIVA
Document: CAM-315
Revision: 01
Date: June 7, 2012

Disassembly Instructions
VIVA
Document: CAM-315
Revision: 01
Date: June 7, 2012
Tools: #2 #3 Phillips Head, Rubber Mallet or Hammer, Allen Key, Box Cutter
Skill Set: Good manual dexterity.
Estimated Time: 15min per chair.
Steps:
1. Armrest - 2min
Turn the chair upside down, so the bottom is visible. Locate the three fasteners locate on the
underside of the seat pan and unfasten. Remove the armrest from the chair. Flip the chair to
the opposing side and repeat the process.
2. Arm Cap - 1min
Turn the arm upside down, so the bottom is visible. Locate the two fasteners and unfasten.
Remove the arm cap from the arm.
3. Back Frame - 2min
Locate the three fasteners located on the underside of seat pan and unfasten. Remove the
backrest and back frame from the chair.
4. Back Rest - 2min
Remove the backrest from the back frame by unfastening two screws located on the underside
of the back rest and back frame.
5. Casters - 2min
Lay chair on back. Grasp and pull to remove casters from the base.
6. Base - 1min
Hold the base legs firmly and strike the bottom of cylinder with a hammer until base comes
loose, remove base.
7. Cylinder - 1min
Remove cylinder by placing one hand on can of cylinder and hit the bottom of the mechanism
with hammer until cylinder separates from mechanism.
8. Mechanism - 2min
Turn the chair upside down, so the bottom is visible. Locate the four fasteners located on the
underside of the seat pan and unfasten. Remove mechanism from the seat pan.
9. Seat - 2min