8 | ENGLISH
Sanitizing is important for hygiene and serves to kill living organisms, such as bacteria or viruses.
Refer to the cleaning and disinfection section for the continued cleaning of your device. Before first use, unless
otherwise directed by your healthcare provider, prepare the product for use as follows:
1. Disassemble all parts & clean using breast pump cleaning instructions. See the
Center for Disease Control website – https://www.cdc.gov/healthywater/hygiene/
healthychildcare/infantfeeding/breastpump.html for additional cleaning guidelines.
2. POP OFF the adapter cap from the flange and refer to the page 8 product
description for the illustration.
3. SET ASIDE adapter cap, tubing and tubing adapter— you do not need to take these
apart from each other. These 3 parts DO NOT need to be washed before first use
or after each use — milk does not come into direct contact with these parts.
NOTE: Inspect the tubing. If you find condensation in the air tube, wash and dry it
immediately or replace the tubing. If you see breast milk inside the tubing or tubing
connector do not attempt to wash, clean or sterilize the tubing or tubing connector.
Instead contact Ameda, Inc.
Take apart the remaining parts, the diaphragm, flange, valve and milk storage bottles, including locking ring
and locking disc, since these are the parts that can touch the breast milk once you begin pumping.
WASH HANDS THOROUGHLY with soap and water before touching breast pump, kit and breasts.
SANITIZE by Boiling
DO NOT allow boiling parts to contact bottom of pot. It may cause damage to parts.
WARNING: DO NOT leave boiling parts unattended. Remove parts carefully from boiling water to
avoid burning. Boiled water and steam from boiled water can cause severe skin burns, so use caution
when boiling parts in water and removing parts from boiling water.
ALTERNATIVE TO BOILING:
SANITIZE in Microwave: Follow steam bag manufacturers' instructions.
IMPORTANT: Set aside tubing, adapter cap and tubing adapter. These parts DO NOT need to
be washed.
• Please check pump kit parts for cracks, chips, tears or deformation before and after sanitization process.
Use only microwave bags specifically labeled for disinfecting breast pump components and refer to the
microwave bag labeling for further instructions.
WARNING: Please use precaution. The major risk with steam bags is scalding so moms and caregivers
should be very careful when they take the bag out of the microwave.
!
!
DO NOT wash adapter
cap, tubing and tubing
adapter.
Ɣĺ"$҃&"$!&$"
5.1 Before First Use: Cleaning The HygieniKit
!
!
CLEAN TUBING: It is necessary to wash the tubing only if condensation is present. If condensation is present
in the tube, wash and dry it immediately or replace the tubing. If milk is present in the tubing, do not attempt
to wash or clean the tubing. Instead contact Ameda Customer Service at 1.866.992.6332.
HOW TO WASH TUBING:
1. Rinse the tubing by pouring cool water and make sure the water flows through the entire tubing from
one end to the other end.
2. Wash the tubing in warm, soapy water and rinse thoroughly.
HOW TO DRY TUBING:
Hang the tubing to air dry and make sure that the tubing is completely dry before using.
