3
• Model Number Congurators
Model Number: PRL - ____ - _____ - _____ - _____ - _____ - _____ - _____
A B C D E F G
A. Range
□017 17 ft (5m)
□050 50 ft (15m)
□100 100 ft (30m)
B. Supply Voltage, Signal
□V115 115 VAC (60 Hz) - 4-wire, Isolated 4-20 mA
□V230 230 VAC (50 Hz) - 4-wire, Isolated 4-20 mA
□V024▲ 12-30 VDC - 3-wire, 4-20 mA w/ shared
common
□V20L 20-35 VDC - 2-wire HART†
C. PC Communications
□C2 RS-232
□C4▲ RS-485
□CH HART†
D. Housing Material
□AL▲Aluminum
□SS 316 Stainless Steel
Note: † CH HART PC Communications requires V20L 20-35 VDC
Supply Voltage
E. Antenna Material
□TE▲ Teon Rod
□TE6 Teon Rod with 6 in. extension
□TE8 Teon Rod with 8 in. extension
□LT Teon Rod with 1.5 in. built-in extension
□ST Sanitary Tri-Clamp mount, Teon Ant.†
□HT High Temperature Radar, Tefon Ant.
□PT High Pressure Tefon Rod Ant.(≤70 bar)†††
□S6 316L Stainless Steel 6” Ø Horn††
□HS High Temperature Radar, 316L SS Horn††
F. Mounting
□T15 1.5 in. NPT
□T2▲ 2 in. NPT
□T3 3 in. NPT
□S15 1.5 in. Sanitary Tri-Clamp (ST only)
□S2 2 in. Sanitary Tri-Clamp (ST only)
□BF 13 in. Ø 316L SS Bottom Flange (S6, HS only)
G. Firmware
□S▲Standard
□F Fast Firmware
□OW Oil-Water Interface Detection††††
Note: † ST Teflon Rod Ant. with Sanitary Tri-Clamp mount
requires S15 1.5 in. or S2 2 in. Sanitary Tri-Clamp
mount
Note: †† S6 and HS 316L SS horns require T3 3 in. NPT or BF
13 in. Bottom Flange mount
Note: ††† PT High Pressure Teflon Rod requires T2 2 in NPT
mount
Note: †††† OW Oil-Water Interface Detection requires Supply
Voltage V024: 12-30 VDC and either TE Teflon Rod
antenna or S6 316L SS horn antenna
▲This option is standard
